曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
BKUP
BRT
C
ONT
RAPID
VSD HSD MMS COMM
PULL
MAN
PULL
BKUP
BRT
C
ONT
RAPID
VSD HSD MMS COMM
ALF
GL
ON
OFF
WPN
ASE
IDM IMAGE
CAPTURE
TIS INTEG
INCR
ON
LMC
ON
ALE
ON
OFF OFF OFF
INIT
START PAGE 2
>TEST-"T"
NO GO
GO
TEST
NETS XXXX
SUBS
AUTH
RAPID
2/3
MSGS
MVT
BULK
>
START PAGE 1
>
>
>
>
>
> ORIG-?
1/3
##:##-TIME
>
>
* TYPE:MENU
AUTO SHOT-OFF
SERIALIZE MSGS
START PAGE 3
3/3
>
ZEROIZE
ON:AUTO POS
TEAM-??
BC-??
CURR NETS
406075-1574-25
J2997
Figure 4-93. TACFIRE Start pages
4-192
TM 1-1520-248-10
communication s h o u l d be r e s t o r e d w i t h t h e 3. Paging (1/3) key Press.
authentication tables in proper sequence.
(4) Preset Messages. There are six preset 4. TEST key Press. Enter a T using MFK; GO
messages that can be programmed prior to the start of or NO GO will display on MFD.
a mission to aid in response time for transmissions.
There are six preset movement packages that can be 5. NETS key Press to access and complete
programmed for establishing phase lines, assembly NET Data pages. Enter prompts as follows:
areas, FARP locations, etc. These 6 preset movement
messages consist of 2 lines of 15 characters each for a a. TFR/AIR NET key Press to scroll type or
total of 30 characters. net desired adjacent to NET number.
(5) BULK Data Load. Bulk data load can be b. BLK key Press to scroll between SGL
used by a team member who did not preprogram the and DBL. Leave as desired.
IDM prior to flight or for an IDM that needs to be
reprogrammed while in flight. The data that can be bulk
loaded from another IDM consists of: subscribers/nets, c. BAUD key Press to select desired baud
preset messages, preset movement messages, receive rate.
automatic authentication table, and transmit automatic
authentication table. d. RADIO key Press to select radio which
will be used for transmitting and receiving.
c . START Page 3/3. This page allows for
configuration of the RAPID function and the e. R-1 key The time required to transmit will
Serialization Subscriber function. The AUTO SHOT display.
function is displayed but is not functional in this
installation. The Start 3/3 page is used to program the f. PRE key Press to access Preamble Entry
programmable RAPID function. The L-1 key allows the page and press PREAMBLE SEC key.
operator to select one of five options to provide quick Enter desired preamble length of 0.1 to 9.9
access to various pages. The five options are as seconds using MFK.
follows: LAST MSG, AIR MSN, ARTY MSN, MAYDAY,
and MENU. NOTE
(1) LAST MSG (Last Message) programs the
RAPID key to display the highest priority new message L-3 (OFF), on the MONITOR page, can be
when activated. pressed to disable monitor function.
(2) AIR MSN (Air Mission) programs the RAPID g. MON key Press if required to access
key to access the currently selected pre-programmed Monitor Entry page and press MONITOR
AIR MISSION SUMMARY page. SEC key. Enter time of from 0.5 to 9.9
(3) ARTY MSN (Artillery Mission) programs the seconds using MFK.
RAPID key to access the currently selected preprogrammed
ARTILLERY MISSION SUMMARY page. h. AUTH key Press to scroll between
MANUAL or NONE.
(4) MAYDAY programs the RAPID key to access
the MAYDAY SUMMARY page.
i. IDM switch on CPG auxiliary control panel
(5) MENU programs the RAPID key to access the Press.
RAPID page. The operator is presented with the four
previously discussed functions. j. R-2 key Press.
k. R-1 key Press to select Start page 2/3. 4-175. TACFIRE CONFIGURATION.
Initialize the IDM as follows: l. NETS Set up each of the eight pages as
required f o r each net to be used by
1. IDM switch Press as required to display repeating steps a. through k.
IDM Index page (Fig 4-94).
m. R-1 key Press as required to return to
2. START key Press. Start page 2/3.
4-193
TM 1-1520-248-10
9. MVT key If desired, press to access Preset
6. SUBS key Press and proceed as follows: Movement Message pages. Enter movement
commands on subpages. Press R-1 key as
NOTE required to return to Start page.
During send operations the user will be 10. BULK key Press if it is desired to upload
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
OPERATOR’S MANUAL FOR ARMY OH-58D HELICOPTER 2(19)
