曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
information.
In the training mode, the HQ II can hop on 16
frequencies which provide 16 NETS for training use.
These NETS are called frequency managed training
nets or FMT-nets. These frequencies are stored in nonvolatile
memory in the RT and need only be loaded
once. Aircrews now use command codes to load WOD
information into the RT processor. This allows insertion
of MWODs. The WOD 20 with cursor must be displayed
when entering one of these command codes at L-3.
Input the command code selected at WOD 20 to the
scratch pad and press the ENTER key.
VERIFY/OPERATE Allows the radio to be placed in
t h e O P E R A T E m o d e a n d e n a b l i n g r a d i o
communication. If the radio is in a mode other than
OPERATE, you will not be able to transmit in either
NORM or AJ modes. To check if a particular day’s
WOD has already been loaded into the radio, press L-3
and toggle the cursor to DATE. Using the MFK, enter
the numerical date (07) followed by the letter V (07V)
and press the ENTER key.
3-12. ENTERING WOD/MWOD INTO UHF HAVE
QUICK RADIOS.
I f a l l users i n the UHF NET are HAVE QUICK
PULL
MAN
PULL
BKUP
BRT
C
ONT
VSD HSD MMS
DEL
STBY
00
0000
M1
M3A
M4A
COMSEC
DOGFLT
3 033.500
PWR NORM PLAIN
A10FLT
12 324.400
PLAIN
UHF T/R
PLAIN
T/R
TOWER
VHF 3 118.200
BRGOPS
17 55.750
PWR LO CIPH FILL 1
FM-2 T/R
FM-1 T/R
RETRAN
UHF
CONTROL
PAGE
T ABCD 01 23455.0
HF R ABCD 01 23455.0 5
PWR LO CIPH FILL 1
RETRAN USB
C 045.500
M 032.475
1 047.500 GROUND
2 052.500 TOWER
3 033.500 DOGFLT
4
5
6
7
8
9
10
11
12
13
14
15
16
17
406075-1420
J3117
equipped, you are the first operator of the day and
there are no Combat WODs loaded, accomplish the Figure 3-8. COMM Page (Frequency List
following: Displayed)
3-16
TM 1-1520-248-10
6. ENTER key on MFK Press. Display will
blink, 20 will appear to right of WOD and NOTE
cursor will be displayed to right of 20.
If fewer than six (6) WOD/MWODs are
NOTE desired press MFK ENTER key twice and
cursor will move to net.
• This indicates acceptance of the date tag
by the radio.
9. Using MFK enter NET data NET data will
• WOD channel storage is not the same as appear to right of NET. Upon entry of data,
the preset channels for other radios cursor and date will be removed from MFD to
stored in the non-volatile memory of the storage in the RT.
MCPU. The WOD/MWOD is stored
directly into the UHF HAVE QUICK radio.
10. KYBD Press. Cursor will appear to right of
• The hundredths/thousandths digits in the L-4. Using MFK enter frequency on which
channel 20 WOD element programs the TOD signal is transmitted. Reference RFD
frequency hop rate with 00 being the (fig. 3-1) or select frequency from preset
slowest and 75 being the fastest. channels on display.
• WOD/MWOD instruction for IDM data
transmission must end in .X00 or .X25. NOTE
7. Using MFK, enter WOD 20 frequency
WOD 20 data entered and channel number If automatic TOD signal is available, press
decrements to 19 with a beep denoting TOD SYNC; if predetermined time is used,
acceptance of 20 data. press TOD SYNC 5 seconds prior; in all
other situations call for TOD on designated
NOTE frequency and press TOD SYNC. If a tone is
not heard within 60 seconds, repeat
process.
• The NET number/instruction combination
follows: NET identification is the ones and
tens to the left of the decimal and the 11. TOD SYNC Press. Listen for a tone
ones to the right (00.0XX); the ability to denoting synchronization.
utilize conferencing is the tenths and
hundredths to the right (XX.X00). 00, 50,
12. BAND Press. Selects one of four phases
and 75 enable conferences, 25 disables
DIPH WIDE, BASE WIDE, BASE NAR, or
conferencing.
DIPH NAR for conferencing.
• IN HQ II, the conferencing capability is
controlled with the Channel 19 frequency/
instruction. Conferencing instructions are NOTE
the same as HQ BASIC (tenths and
hundredths to the right of the decimal)
with 00, 50, and 75 enabling and 25 • In the AJ mode, selecting certain net
disabling. numbers causes the bandwidth to
automatically go to narrow.
8. Using MFK enter WOD data A beep will be
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
TECHNICAL MANUAL OPERATOR’S MANUAL FOR ARMY OH-58D HELICOPT(45)
