曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
3-14
TM 1-1520-248-10
(4) Common hopping rate (Speed).
(5) Common net identification (NET).
NOTE
• An HQ II radio can accept a basic HQ
WOD; however, a basic HQ radio cannot
a c c e p t a n M W O D ( b a c k w a r d s
compatibility).
• A communications channel, in the AJ
mode, is defined by a net number (NET)
instead of a single frequency as in the
NORM mode.
• T/R+G GUARD monitor is operational
during AJ operation. To transmit on
GUARD frequency select NORM and
EMER T/R or press MFK EMER button.
The UHF HAVE QUICK radio series must be initialized
before operating in the AJ mode. This consists of
entering the WOD/MWOD, TOD, and NET data. WOD/
MWOD is entered by accessing the COMM page (fig. 3-
PULL
MAN
PULL
BKUP
BRT
C
ONT
VSD HSD MMS
406075-1413-1
J0546
DOGFLT
FM-1 T/R 3 033.500
PWR NORM PLAIN
A10FLT
12 324.400
PLAIN
UHF T/R
PLAIN
T/R
TOWER
VHF 3 118.200
T ABCD 01 23455.0
HF R ABCD 01 23455.0 5
PWR LO CIPH FILL 1
RETRAN USB
BRGOPS
FM-2 T/R 17 55.750
PWR LO CIPH FILL 1
RETRAN
DEL
STBY
00
0000
M1
M3A
M4A
RETRAN
ADD
COMSEC
7) then selecting the UHF Radio Control page (fig. 3-6).
WOD/NET or DATE/WOD/NET will be displayed at L-3. Figure 3-7. COMM Page
WOD/NET denotes basic HQ or DATE/WOD/NET
denotes HQ II.
should be double and preamble should be
NOTE 3.0 or higher.
In HQ II the DATE information (numeric The HQ II allows selection of two separate groups of
calendar day-of-month) must be entered 1,000 nets. Both groups of nets are referred to as
f i r s t . The WOD/MWOD instructions/ frequency managed A-nets or FMA-nets.
frequencies are entered in the six preset
channels; 20 through 15. After completion of The expanded memory board (EMB) modification will
the WOD/MWOD entries the cursor will accept up to six days of word-of-day (WOD) creating a
move to the NET position. At that point NET multiple-word-of-day (MWOD). EMB radios will
number/instructions may be entered. automatically reset themselves to the next day’s key
when operated past 2400 hours ZULU.
The universal time-of-day (TOD) is normally entered
before flight, but it is possible to enter it in flight. The HQ II system has the same conferencing options
Momentary depression of the TONE key transmits the as the basic HQ radio. This option is determined by the
timing synchronization information (1167 Hz tone) in WOD element in Channel 19 instead of the NET
both NORM and AJ modes from a radio with TOD. number. All training and combat WODs are configured
Continued depression of the TONE key will cause to have conferencing available.
generation of a 1020 Hz tone following the TOD signal.
A complete TOD message is transmitted in the NORM
mode. An abbreviated time synchronization update is NOTE
transmitted in the AJ mode. TOD is also available from
EGI by using the EGI sync feature. Conferencing must be disabled for digital
and secure traffic.
NOTE
NET SELECTION: The last two digits tell the radio how
During IDM operations on a HAVE QUICK it is to function. The following are examples of combat
net baud rate should be 600 or less, block nets:
3-15
TM 1-1520-248-10
00 Operate as a basic HQ 1. COMM key (or DSPL SEL switch) Press.
25 HQ II NATO Hopset COMM page (fig. 3-7) will display.
50 HQ II non-NATO Hopset
75 Not Used (Interrupted Fault Tone). 2. UHF key or collective frequency select switch
if UHF is selected Press. UHF radio
The following are examples of training nets: frequency list will display (fig. 3-8).
00 Basic HQ Training
25 HQ II Training 3. R-5 key Press. UHF Radio Control page
(fig. 3-6) will display.
50/75 Not Used (Fault Tone).
Additional information is required for which WOD to use
on a particular day. Successive pressing of the L-3 key 4. DATE/WOD/NET key Press. Cursor will
will cause the cursor to toggle between DATE, WOD, display to right of DATE.
and NET. Since the HQ II WODs are identified by a
specific date, the radio must have the current date
entered into the system. This information can be NOTE
entered in two ways:
Basic HQ radio will have no date entry
1. Insert the current day, using the MFK, to the function and only one set of WODs.
right of the DATE and press the ENTER key
on the MFK.
5. Enter two-digit date using MFK Numbers
2. Receive a HQ II TOD which contains date will appear to right of DATE.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
TECHNICAL MANUAL OPERATOR’S MANUAL FOR ARMY OH-58D HELICOPT(44)
