曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
for the locking screw. Engage the screw.
Refer to Figure 6
(3) Turn the screw counter-clockwise until the
unit disengages from the mounting rack.
CAUTION: DO NOT PULL ON THE KNOBS. DO NOT PRY THE FACE-PLATE.
YOU CAN DAMAGE THE UNIT.
CAUTION: DO NOT TOUCH THE CONNECTOR CARD AT THE REAR OF THE
UNIT. THE ELECTROSTATIC CHARGE ON YOUR BODY CAN
DAMAGE THE UNIT.
(4) Pull gently on the sides of the unit to remove
it from the mounting rack.
(5) Install the protective covers on the rear
connectors of the GPS.
B. Install the Bendix\King KLN 35A GPS Receiver
Detail Steps/Work Items Key Items
(1) Remove the protective covers from the
connectors on the replacement unit.
(2) Slide the unit into the rack. Engage the
locking screw so that the latch front lobe
touches the rack.
(3) Turn the locking screw clockwise so that the
rear lobe engages the mounting rack.
Refer to Figure 6
CAUTION: DO NOT OVER-TIGHTEN THE LOCKING SCREW. YOU CAN
DAMAGE THE LOCKING MECHANISM
(4) Continue to turn the screw until the unit is
fully installed in the mounting rack.
(5) Close the GPS circuit-breaker.
(6) Do an operational test.
Navigation
DA20-C1 AMM
Page 206
19 Dec 1997 34-50-00 Doc # DA 201-C1
Rev. 0
C. Adjustment/Test KLN 35A GPS Receiver
Refer to the Bendix\King Operator’s Handbook #006-08791-0000 gives start-up and operating
procedures.
WARNING: DO NOT USE THE GPS WITH AN OUT-OF-DATE DATA BASE. AN
OUT-OF-DATE DATA CAN CAUSE A FLIGHT SAFETY HAZARD.
Detail Steps/Work Items Key Items
(1) Do a test of each control function.
(2) Make sure that the data base date is valid.
(3) Move the airplane clear of buildings and
ground equipment.
(4) Bring the unit to the NAV READY status. If the unit does not reach NAV READY
status in 5 minutes, refer to the
manufacturer’s handbook.
D. Data Base Loading
You load the data base with an IBM compatible lap-top computer with a 3.5 in disk drive and an
open COM1 or COM 2 port. Use interface kit Bendix\King part number 050-03213-0000.
Detail Steps/Work Items Key Items
(1) Connect the PC to the data loading port
below the left instrument panel shelf.
(2) Set the KLN 35A to the SET 0 page.
(3) Put the diskette in the PC.
(4) Cycle the power of the PC. Follow the menu
instructions.
DA20-C1 AMM
Navigation
Doc # DA 201-C1
Rev. 0 34-50-00 Page 207
19 Dec 1997
5. Remove Install the Bendix\King KLX 135/135A GPS COMM
A. Remove the Bendix\King KLX 135/135A GPS COMM
Detail Steps/Work Items Key Items
(1) Open the related GPS COMM 1 or 2 circuitbreaker.
(2) Put a 3/32 allen wrench into the access hole
for the locking screw. Engage the screw.
Refer to Figure 7
(3) Turn the screw counter-clockwise until the
unit disengages from the mounting rack.
CAUTION: DO NOT PULL ON THE KNOBS. DO NOT PRY THE FACE-PLATE.
YOU CAN DAMAGE THE UNIT.
CAUTION: DO NOT TOUCH THE CONNECTOR CARD AT THE REAR OF THE
UNIT. THE ELECTROSTATIC CHARGE ON YOUR BODY CAN
DAMAGE THE UNIT.
(4) Pull gently on the sides of the unit to remove
it from the mounting rack.
(5) Install the protective covers on the rear
connectors of the GPS.
B. Install the Bendix\King KLX 135/135A GPS COMM
Detail Steps/Work Items Key Items
(1) Remove the protective covers from the
connectors on the replacement unit.
(2) Slide the unit into the rack. Engage the
locking screw so that the latch front lobe
touches the rack.
(3) Turn the locking screw clockwise so that the
rear lobe engages the mounting rack.
Refer to Figure 7
CAUTION: DO NOT OVER-TIGHTEN THE LOCKING SCREW. YOU CAN
DAMAGE THE LOCKING MECHANISM.
(4) Continue to turn the screw until the unit is
fully installed in the mounting rack.
(5) Close the related circuit-breaker.
(6) Do a operational test.
Navigation
DA20-C1 AMM
Page 208
19 Dec 1997 34-50-00 Doc # DA 201-C1
Rev. 0
C. Adjustment/Test KLX 135/135A GPS COMM
If possible, do an operational flight check after the radio has been replaced. Alternatively, use a
NAV COMM test set to make sure that the system operates correctly. Refer to the Bendix\King
installation manual #006-10500-0003 for performance specifications.
Refer to the Bendix\King Operator’s Handbook (#006-08751-0000 for the KLX 135, #006-08789-
0000 for the KLX 135A) which gives start-up and operating procedures.
WARNING: DO NOT USE THE GPS WITH AN OUT-OF-DATE DATA BASE. AN
OUT-OF-DATE DATA CAN CAUSE A FLIGHT SAFETY HAZARD.
Detail Steps/Work Items Key Items
(1) Do a test of each control function.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
钻石20系列AMM 2(36)
