日期： 2011-03-28 13:44:42
(7) On the Valveblock, do a check for circuit isolation. (a) For the POB solenoid connect the pins L K together. (b) Connect one test lead of the 45Vdc Isolation Tester to the pins LK and the other test lead to pin G. (c) Supply a test sig...
日期： 2011-03-28 13:42:00
TASK 27-00-00-810-801 Display of an Operational Warning on the Upper ECAM DU 1. Possible Causes _______________ - Message on the Post Flight Report (PFR) 2. Job Set-up Information ______________________ Not Applicable 3. Fault Confirmation...
日期： 2011-03-28 13:28:37
HIGHLIGHTS __________ REVISION NO. 30 Aug 01/05 Pages which have been revised are outlined below, together with the Highlights of the Revision CH/SE/SU C REASON FOR CHANGE EFFECTIVITY PAGES CHAPTER 26 L.E.P. 1- 3 REVISED TO REFLECT THIS RE...
日期： 2011-03-28 13:22:42
R TASK 24-22-00-810-823 R Failure of the GLC 1 or Loss of its Status Indication R 1. Possible Causes _______________ R - GCU-1 (1XU1) R - RELAY (20XU) R - GLC-1 (9XU1) R - wiring R 2. Job Set-up Information ______________________ R A. Refe...
日期： 2011-03-28 09:47:43
1 . If the IDG2 filter element is damaged or, _ . If the filter element is bypassed (metal particles on the filter element) or, . If you think it was bypassed (filter not installed correctly, or filter O-ring damaged, or you are not sure t...
日期： 2011-03-28 09:44:53
HIGHLIGHTS __________ REVISION NO. 30 Aug 01/05 Pages which have been revised are outlined below, together with the Highlights of the Revision CH/SE/SU C REASON FOR CHANGE EFFECTIVITY PAGES CHAPTER 24 L.E.P. 1- 9 REVISED TO REFLECT THIS RE...
日期： 2011-03-28 09:27:20
CABIN AND SERVICE INTERPHONE - FAULT ISOLATION PROCEDURES _________________________________________________________ TASK 23-44-00-810-801 Fault of the Communication between the Cockpit/Cabin and an Outboard Service Interphone Station 1. Po...
日期： 2011-03-28 09:24:34
HIGHLIGHTS __________ REVISION NO. 30 Aug 01/05 Pages which have been revised are outlined below, together with the Highlights of the Revision CH/SE/SU C REASON FOR CHANGE EFFECTIVITY PAGES CHAPTER 23 L.E.P. 1- 6 REVISED TO REFLECT THIS RE...
日期： 2011-03-28 09:22:49
2. Job Set-up Information ______________________ A. Referenced Information -------------------------------------------------------------------------------REFERENCE DESIGNATION ---------------------------------------------------------------...
日期： 2011-03-28 09:19:52
REVISION NO. 30 Aug 01/05 Pages which have been revised are outlined below, together with the Highlights of the Revision CH/SE/SU C REASON FOR CHANGE EFFECTIVITY PAGES CHAPTER 22 L.E.P. 1- 5 REVISED TO REFLECT THIS REVISION INDICATING NEW,...
日期： 2011-03-28 09:16:40
A. If the pack 1 flow indicator on the ECAM BLEED page is stuck in the high position: NOTE : Do the following step only, if the FCV is of the standard: ____ - PN 751A0000-07 Amdt. ABC or, - PN 751A0000-07 Amdt. BC or, - PN 751B0000-02 Amdt...
日期： 2011-03-28 09:13:17
HIGHLIGHTS __________ REVISION NO. 30 Aug 01/05 Pages which have been revised are outlined below, together with the Highlights of the Revision CH/SE/SU C REASON FOR CHANGE EFFECTIVITY PAGES CHAPTER 21 L.E.P. 1- 6 REVISED TO REFLECT THIS RE...
日期： 2011-03-27 22:27:10
HIGHLIGHTS __________ REVISION NO. 30 Aug 01/05 Pages which have been revised are outlined below, together with the Highlights of the Revision CH/SE/SU C REASON FOR CHANGE EFFECTIVITY PAGES CHAPTER 25 L.E.P. 1- 1 REVISED TO REFLECT THIS RE...
日期： 2011-03-27 22:23:54
HIGHLIGHTS __________ REVISION NO. 30 Aug 01/05 Pages which have been revised are outlined below, together with the Highlights of the Revision CH/SE/SU C REASON FOR CHANGE EFFECTIVITY PAGES CHAPTER 05 L.E.P. 1- 1 REVISED TO REFLECT THIS RE...
日期： 2011-03-27 22:23:01
REVISION NO. 30 Aug 01/05 Pages which have been revised are outlined below, together with the Highlights of the Revision CH/SE/SU C REASON FOR CHANGE EFFECTIVITY PAGES CHAPTER 00 L.E.P. 1- 1 REVISED TO REFLECT THIS REVISION INDICATING NEW,...
日期： 2011-03-27 22:15:39
CES 1. The Temporary Revisions which follow have been included in the revision dated Aug 01/05 and must be removed and discarded. Update the Record of Temporary Revision. TR N. None. 2. The Temporary Revisions issued after Jul 15/05 must b...
日期： 2011-03-27 22:14:31
NSA932031 - 01 NSA932033 - 01 | | | -------------------- Unit reference ---------------------------- Standard P/N (2) P/N characteristics (a) Temperature Minimum operating temperature is -60 deg.C (-76.00 deg.F) Maximum operating temperatu...
日期： 2011-03-27 22:13:19
F. NSA931026 (1) P/N Identification NSA931026 - 01 | | | -------------------- Code number ------------------------------ Standard P/N G. NSA931028 (1) P/N Identification NSA931028 - 02 A | | | | | ---------------- Size code | -------------...
日期： 2011-03-27 22:11:41
Hand Crimping Tool-SOURIAU P/N CCT 1612 R Figure 028 20-25-22 Page 58 Hand Crimping Tool - DANIELS M309 R Figure 029 20-25-22 Page 59 _________________________________________________________ HYDRAULIC HAND CRIMPING TOOLS - DESCRIPTION AND...
日期： 2011-03-27 22:08:46
__________HIGHLIGHTS REVISION NO. 09 Apr 01/05 Pages which have been revised are outlined below, together with the Highlights of the Revision CH/SE/SU C REASON FOR CHANGE EFFECTIVITY PAGES CHAPTER 20 L.E.P. 1-16 Revised to Reflect this rev...
