Positioning of "BSB" transfers
Figure 202 (3/3)
AAAA
Validity : S / N 1 — 9999 20-00-05Page 203
(BA) DEC 98
4) Particular precautions
In case of bad application :
a) On moist film :
Remove the film and only after doing again and reapplying all area preparation works, proceed to a new application.
b) On dry film :
Using a methyl—ethyl—ketone (TB 11-003) soaked cloth, impregnate the film and remove it by rubbing with the plastic scraper.
CAUTION : TO ENSURE A PERFECT FILM POLYMERIZATION, DO NOT CLEAN THE AIRCRAFT CONCERNED AREAS DURING THREE OR FOUR DAYS.
5) Checking
Make sure that transfers are correctly positioned on aircraft, that no folds and / or no air bubbles appear and that edges perfectly adhere.
D. Positioning of "DISA" transfers (Figure 202)
1) Sequences of operations :
Area preparation
a) Mark the place of transfers to be positioned,
b) Carefully clean area with a C gasoline (TB 11-918) or F gasoline (TB 11-919) soaked cloth.
2) Work on the aircraft
Before positioning the transfers on the aircraft, plunge them during 10 seconds in the "DISA" decal solvent 527B (TB 07-905).
NOTE : Use new decal solvent for each aircraft.
3) Proceed in the same way as for "BSB" transfers — see Paragraph C. (steps 3), 4) and 5)).
E. Materials required for positioning of polycarbonate grey self—adhesives (POLY) or transparent tapes (ADH)
— Rilsan scraper
— Hard rubber roller
— G gasoline (TB 11-916)
— Clean lintfree cloths
F. Positioning of polycarbonate grey self—adhesives or transparent tapes
1) Sequences of operations :
Area preparation
a) Mark the place of self—adhesives to be positioned.
b) Carefully clean area with a cloth soaked only with G gasoline (TB 11-916).
1 2) Installation
a) Fit the self—adhesive over the foreseen exact position with the adhesive part facing the aircraft area.
b) With hand, put one of the edges in contact with the area and hold the other self—adhesive edge stretching it lightly to avoid folds.
c) Put the self—adhesive in contact with the application area using a plastic scraper or an applying roller.
d) Flatten, if necessary, by firmly pressing on the scraper to remove folds and air bubbles. 3) Checking
Make sure that self—adhesives are correctly positioned on aircraft, that no folds and / or no air bubbles appear and that edges perfectly adhere.
AAAA
Validity : S / N 1 — 9999
20 00 05 (BA) P aDgEec290:
PAGE INTENTIONALLY LEFT BLANK
I AAAA
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：TB20 MAINTENANCE MANUAL 20 STANDARD PRACTICES AIRFRAME TB20飞机维护手册 20 标准施工机体(43)
