NOTE : Concerning Dia. column, the values given in fraction are in inches, the other values are in mm.
The tightening torque values given in lbf.in have been rounded off.
For some tightening torques (marked with an asterisk) a specific tightening process is required - refer to Paragraph C.
For attachments provided with a castellated nut and a pin, tighten to the indicated tightening torque then loosen, if necessary, to introduce the pin.
ABAA
Validity : S / N 1 - 9999 20 00-01Page 204
(BA) SEP 04
Item Attachment designation Bolt Torques
in N.m Torques
in lbf.in
Dia. Pitch
161 "Inlet" and "Outlet" pipes / Nose and main landing gear actuating cylinder 7/16 11.3 to 28.2 100 to 250
162 Flow governor / Nose landing gear cylinder ("inlet" port) 7/16 11.3 to 28.2 100 to 250
163 Main gear not lubricated hinged strut / 72 hinged strut fitting 8
8 1.25
1.25 Fully tightened by hand
and pinned
163 Main gear lubricated hinged strut / 1/2 hinged strut fitting 8
8 1.25
1.25 9 80
164 Hinged strut / main landing gear body 8 1.25 11 97
165 Hinged arm / landing gear body 14 1.50 60 531
166 Main landing gear wheel 1/2 rims 5/16 17 150
167 Grease nipple 6 4 35
168 Drain nut / fuel filter 15 132.75
169 Nose landing gear door / landing gear body 5 0.80 5 44
170 Landing gear cylinder fork end / jam nut 8 1.25 13 115
201 * Main landing gear hinge fitting /
spar 8 1.25 11 97
202 * Main landing gear strut hinge fitting
/ spar 5 0.80 2.5 22
203 * Main landing gear actuator hinge
fitting / spar 5 0.80 2.5 22
204 Low level sensor / sealed rib 10.8 96
205 Bleed body / wings 16 1.50 27 239
206 Capacity gages / wing spar 4.45 to 4.5 39.4 to 40
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：TB20 MAINTENANCE MANUAL 20 STANDARD PRACTICES AIRFRAME TB20飞机维护手册 20 标准施工机体(10)
