曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
Consequently, he should :
• Manually TUNE in the ILS on the RAD NAV page : CHECK that the
"CHECK APPR GUIDANCE" message comes up.
• Press the ILS pushbutton and select ROSE ILS on the EIS CONTROL
panel.
• Use HDG, V/S or TRK, FPA modes to fly the ILS.
SWITCHING FROM NON ILS TO ILS APPROACH
Applicable to:
,
,
MSN,,,,
If an ILS approach is possible when a non ILS was previously scheduled, use one of the following
procedures :
USE OF SECOND FLIGHT PLAN
Use a secondary flight plan to prepare the alternate ILS approach, time permitting.
COPY the ACTIVE flight plan.
REVISE the ARRIVAL : insert the ILS approach and the applicable STAR/VIA.
On the RAD NAV page, TUNE in the ILS manually.
A318/A319/A320/A321 FLIGHT CREW
OPERATING MANUAL
PROCEDURES
NORMAL PROCEDURES
SYSTEMS RELATED PROCEDURES - FMS
A318/A319/A320/A321 FLEET PRO-NOR-SRP-01-70 P 12/42
FCOM 19 AUG 10
REVISE the PERF APPR page.
CHANGE OF THE CLEARANCE
ATC changes the clearance from the non-ILS to the ILS approach.
If a secondary flight plan has been prepared :
ACTIVATE the SEC F-PLN and adjust.
Follow subsequent standard procedures.
If a secondary flight plan has not been prepared :
REVISE the ARRIVAL on the primary F-PLN, inserting the ILS approach.
REVISE the PERF APPR page.
Follow subsequent standard procedures.
CAUTION If the pilot decides to fly the ILS approach without revising the arrival of the
primary flight plan (a non ILS approach is in the F-PLN), LOC and G/S modes
will not be available when he presses the APPR pushbutton.
Consequently, he should :
• Manually TUNE in the ILS on the RAD NAV page : CHECK that the
"CHECK APPR SELECTION" message comes up.
• Press the ILS pushbutton and select ROSE ILS on the EIS CONTROL
panel.
• Use HDG, V/S or TRK, FPA modes to fly the ILS.
TASK SHARING DURING CAT I, CAT II AND CAT III APPROACH AND LANDING
Applicable to:
MSN,
Refer to LIM-22-20 CATEGORY II provides all limitations regarding CAT I, CAT II and CAT III
approaches and landings. This includes precautions to be taken when performing autoland on CAT I
ILS beam with good visibility.
A318/A319/A320/A321 FLIGHT CREW
OPERATING MANUAL
PROCEDURES
NORMAL PROCEDURES
SYSTEMS RELATED PROCEDURES - FMS
A318/A319/A320/A321 FLEET PRO-NOR-SRP-01-70 P 13/42
FCOM 19 AUG 10
Anytime a precision approach is performed the PNF must announce that a flight parameter is being
exceeded, if :
‐ During glide beam capture
• Pitch attitude becomes less than minus 2.5 ° or greater than plus 10 ° (nose up).
• Vertical speed exceeds plus 500 ft/min or minus 1 250 ft/min.
‐ During final approach
• Speed goes below speed target minus 5 kt or above speed target plus 10 kt (announce
“SPEED”).
• Pitch attitude goes below minus 2.5 ° or above 10 ° (announce “PITCH”)
• Bank angle becomes greater than 7 ° (announce “BANK”)
• Descent rate becomes greater than 1 000 ft/min (announce “SINK RATE”)
• There is too much LOC or GLIDE deviation (announce “LOCALIZER” or “GLIDE”).
If the flight crew suspects that autopilot guidance is not effective, they should :
‐ Use the instinctive disconnect pushbutton to disconnect the autopilot, or
‐ Perform an automatic go-around.
The flight crew may perform a CAT II/CAT III approach, if :
‐ The FMA displays the corresponding category
‐ The required systems and functions are operative
‐ The airport is approved for the intended operations.
‐ They are qualified to perform the specific approach.
CAT III APPROACH
AUTO CALL OUT RA is mandatory
A/THR in SPEED MODE is mandatory.
Note: AUTO CALL OUT is not mandatory for CAT 2 approach : The PNF may perform this
function.
TASK SHARING DURING CAT I, CAT II AND CAT III APPROACH AND LANDING
Applicable to: ,
, MSN,,
Refer to LIM-22-20 CATEGORY II provides all limitations regarding CAT I, CAT II and CAT III
approaches and landings. This includes precautions to be taken when performing autoland on CAT I
ILS beam with good visibility.
A318/A319/A320/A321 FLIGHT CREW
OPERATING MANUAL
PROCEDURES
NORMAL PROCEDURES
SYSTEMS RELATED PROCEDURES - FMS
A318/A319/A320/A321 FLEET PRO-NOR-SRP-01-70 P 14/42
FCOM 19 AUG 10
Anytime a precision approach is performed the PNF must announce that a flight parameter is being
exceeded, if :
‐ During glide beam capture
• Pitch attitude becomes less than minus 2.5 ° or greater than plus 7,5 ° (nose up).
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
A320机组操作手册FLIGHT CREW OPERATING MANUAL 12(85)
