曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
WARNING
Danger of injury!
USE THE OVEN CONTROL MODULE only FOR designated PURPOSES!
Obey the Warnings and CAUTIONs APPLICABLE to the oven!
COMPONENTS
TR1 A318/A319/A320/A321 FLEET CCOM Page 35 of 53
CABIN CREW OPERATING MANUAL
CABIN INTERIOR
GALLEYS
02.140
JAN 08/08
OVEN CONTROL MODULE COMPONENTS
NOC 02140 02382 0001
-- Heating time display (heating time selector switches below)
-- Temperature indicator lights (temperature selector switch below)
-- Serving time display (serving time selector switches below)
-- ON/OFF button
-- Start button
GENERAL OPERATION
Set the required heating time and the heating temperature at the front panel.
The temperature sensor in the oven gives the signals to the OVEN CONTROL
MODULE to control oven operation.
You can use three heating temperatures:
Selection Temp in degree
Celsius
Temp in degree
Fahrenheit
1. low 145 293
2. med 185 365
TR1 A318/A319/A320/A321 FLEET CCOM Page 36 of 53
CABIN CREW OPERATING MANUAL
CABIN INTERIOR
GALLEYS
02.140
JAN 08/08
Selection Temp in degree
Celsius
Temp in degree
Fahrenheit
3. high 230 446
The appropriate indicator of the used heating temperature lights up at the front
panel.
Conditions:
-- The max. heating time is 60 minutes.
-- The used heating time is shown at the front panel.
-- The max. serving time is 90 minutes.
-- The used serving time is shown at the front panel.
-- While the soak time only the blower is working.
-- After the program is done, the OVEN CONTROL MODULE switches off the
system.
-- In case power supply is interrupted while the oven is operating, data for oven
operating will be kept for two minutes. If the power supply returns within two
minutes, the OVEN CONTROL MODULE will continue to operate automatically.
The OVEN CONTROL MODULE identifies the following failures:
-- temperature sensor short-circuit.
-- temperature sensor breaking.
-- overheating of the oven to more than 290 degrees Celsius (554 degrees
Fahrenheit).
STARTING OPERATION
1. Press the key, ON/OFF.
The display shows 00.
The indicators MED and ON/OFF light up.
2. Setting the serving time (right segment) and the heating time (left segment).
Set the serving time and the heating time with separate keys for the two
decimal places.
When you press a key, the adjusted time will increase by approximately one
value per second.
The max. heating time is 60 minutes.
The max. serving time is 90 minutes.
TR1 A318/A319/A320/A321 FLEET CCOM Page 37 of 53
CABIN CREW OPERATING MANUAL
CABIN INTERIOR
GALLEYS
02.140
JAN 08/08
Note: The serving time is the elapsed time from program start to serving the
prepared meal. Normal the serving time should be two minutes more
than the heating time, because of the two minutes soak time after the
heating process. For further information see the description below.
To start the oven immediately:
-- Select the heating time.
-- Select the serving time max. two minutes more than the heating time.
Heating elements and blower are switched on immediately and the heating
process starts.
After the end of the heating time, two minutes serving time are left, which
pass as soak time
To start the oven by input the elapsing time, you wish to serve the meal:
-- Select the heating time.
-- Select the serving time. The serving time has to be more than two minutes
more than the heating time.
Serving time passes until the serving time is two minutes more than the
heating time. Then the heating elements and the blower are switched on and
the heating process starts.
After the end of the heating time two minutes serving time are left, which
pass as soak time
3. To set the temperature press the TEMP key and the adjusted temperature and
the respective indicator changes as follows:
MED - HIGH - MED - LOW - MED - HIGH - MED - LOW
4. To start the program press the key START. The START indicator lights up.
Additional features:
-- If you press the TEMP key the actual temperature in the oven is shown for
three seconds.
Example: 14 5C = 145°C
-- After the end of the program the time display " - -" flashes for ten minutes.
Than the Oven Control Module switches off the complete system.
-- You can switch off the Oven Control Module at any time if you press the
ON/OFF key. All adjusted values are then lost.
TR1 A318/A319/A320/A321 FLEET CCOM Page 38 of 53
CABIN CREW OPERATING MANUAL
CABIN INTERIOR
GALLEYS
02.140
JAN 08/08
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
A320_Generic_Training_CCOM 上(36)
