F 『
E C F M E
E E
E 56 E
E E
(1) If there is 28VDC:
- replace the HMU (Ref. AMM TASK 73-21-10-000-002) and (Ref. AMM TASK 73-21-10-400-002).
(2) If there is no 28VDC:
- remove the panel 115VU.
- do a check of the aircraft wiring between the connector 4000KC-A and the ENG/MASTER control switch (2KC) pin AA/1 to pin 1G.
- do a check of the aircraft wiring between the ENG/MASTER control switch (2KC) pin 3G and the circuit breaker (1KC2) (Ref. ASM 76-12/01).
(a) If the wiring is not correct:
- repair the above defective wirings.
(b) If the wiring is correct:
- replace the CTL SW-ENG/MASTER 2 (2KC) on the panel 115VU. (Ref. R AWM 76-12-01)
- install the panel 115VU and do a test program after removal/installation of a VU panel. (Ref. AMM TASK 31-10-00-700-001)
C. Test
(1) Start the engine 2 by the engine automatic start procedure (Ref. AMM TASK 71-00-00-710-003).
(2) Make sure that there is no ECAM and CFDS fault message shown.
F 『 EEFF : ALL E ∞∞76-12-00∞∞∞∞∞∞∞∞∞∞Page 216
E E Aug 01/05 E E ECES
E
F 『
E C F M E
E E
E 56 E
E E
TASK 76-12-00-810-816
Failure of the Control of the Fuel Shut-off Valve on Engine 1
1. Possible Causes
_______________
- aircraft wiring
- RELAY-ENG/MASTER 1 (11QG)
- ACTUATOR-LP FUEL VALVE, ENG 1 (9QG)
- VALVE-LP FUEL, ENG 1 (12QM)
- CTL SW-ENG/MASTER 1 (3KC)
- ECU (4000KS)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 28-24-00-710-002 Operational Test of the ENG 1(2) LP Fuel Valve 12QM
(13QM) R AMM 28-24-41-000-001 Removal of the LP Fuel Valve 12QM(13QM) R AMM 28-24-41-400-001 Installation of the LP Fuel Valve 12QM(13QM)
AMM 28-24-51-000-001 Removal of the LP Fuel Valve Actuator AMM 28-24-51-400-001 Installation of the LP Fuel Valve Actuator AMM 71-00-00-710-003 Engine Automatic Start AMM 73-21-60-000-001 Removal of the Electronic Control Unit (ECU)(4000KS) AMM 73-21-60-400-001 Installation of the Electronic Control Unit
(ECU)(4000KS)
ASM 28-24/01
ASM 76-12/01
3. Fault Confirmation
__________________
A. Test
(1) Not applicable, the fault is evident.
4. Fault Isolation
_______________
A. Table of the circuit breakers used in this procedure:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FUEL/LP VALVE/MOT1/ENG1 1QG A08 121VU FUEL/LP VALVE/MOT2/ENG1 3QG M25
F 『 EEFF : ALL E ∞∞76-12-00∞∞∞∞∞∞∞∞∞∞Page 217
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320 Trouble Shooting Manual 排故手册 发动机控制(24)