(R)
0 TEST button Activates IO-second maximum internal test of the RFCI. On successful
completion of the test, the LCDs show the test display. If the TEST button
is held for more than 10 seconds the display will automatically return to the
display prior to test.
Figure 19-7. Radio Frequency/ChanneIln dicator (Sheet 1 of 2)
19-11 ORIGINAL
NAVAIR 0%F14AAD-1
“n.reUP, cn,mE I FUNCTION ,.“,.,~m.Y~m”m.- . _.__.. -._
@
VOL control Enable RIO to adjust level of audio signal. Clockwise rotation increases
audio level.
0 XMTR SEL buttons Enables RIO to select desired radio for voice communications (V/UHF or
JTIDS).
Note
When JTIDS voice communications is selected V/UHF plain voice
communications are inhibited. If V/UHF encrypted voice communication is
selected, both V/UHF (encrypted) and JTIDS will transmit simultaneously.
Figure 19-7. Radio Frequency/ChanneIln dicator (Sheet 2 of 2)
19.3.4 Have Quick Load instructions. Have Quick
antijam voice communications entry uses preset chatinel40.
The contentso f presetc hannel4 0 designatesth e
loadingm odei n which thennit is operatingT. he following
loading codes are used tc operate and load in Have
Quick II:
1. 220.000 - Qperate in Have Quick II.
2. 220.025 - MWOD load mode.
3. 220.050 - MWOD erase mode.
4. 220.075 - FMT load mode.
If the aircrew desiis to enter Have Quick without
loading or verifying, 220.000 should be loaded into preset
channel 40 using the procedures in paragraph
19.3.4.13.o therwise, Have Quick I processingi s used.
19.3.4.1 Net Selection. Have Quick I and II use the
same method of net selection. A net is a six-digit number
that selects the frequency table that will be hopped on.
Net numbers are in the form of AXXXYY, where A
indicates a Have Quick net, X is a number Tom 0 to 9
deftig the net, and W is either 00,25,50, or 75, which
determines the combat or training operational mode.
The operational modes am
1. COMBAT
a. 00 - Qperate in Have Quick I.
b. 25 - Have Quick II NATO.
c. 50 - Have Quick II Non-NATO.
d. 75 - Not Used.
2. TRAINING
a. 00 - HaveQuickITmining.
b. 25 - Have Quick II Training.
c. 50/75 - Not Used.
The 1,000 combat nets range t?om 000 to 999. The
variables in these net numbers refer the radio to specific
frequencies and algorithms within the radio’s memory.
There are five Have Quick I tmining nets displayed as
AOO.XOOw, here X is 0 to 4. There are 16 Have Quick
II training nets displayed as AOXX25, where X.X is 0.0
to 1.5. The variables in these training net numbers tell
the radio the training thequencyo n which to begin hopping.
Training nets are activated by a special WOD
(300.0X39 in segment one of the WOD used for that
dsy. The last two digits determine the hop rate. The same
applies tc the last two digits of the fmt segment of
combat WODs.
19.3.4.2 Word of Day/Multiple Word of Day. A
WODiMWOD is a transmission security variable. Have
Quick I radios use a WOD consisting of six segments of
six digits each. Have Quick II radios use a MWOD that
adds a seventh segment containing a two-digit date tag
and live more MWODs for 6 days of operation without
reloading WODs. The WODMWOD is loaded into the
radio to key the Have Quick system tc the proper hopping
pattern, dwell time, and hop rate. The hop rate is
included in the fast segment of each WODMWOD.
XXXXYY, where YY is 00,25,50,75, denoting slow
to fast hop rates. When operating with Have Quick I
systems, only one ofthe six MWODs is used. See Figure
19-10.
ORIGINAL 19-12
NAVAIR 01.F14AAD-1
JTIDS 7
NOMENCIATURE FUNCTION
3
JTIDS SEL switch Selects JTIDS 1 or 2 voice channel for pilot’s voice transmissions. Both
channels are always selected to receive.
3
JTIDS-1, JTIDS-2,
V/UHF-2 volume
Clockwise rotation increases audio level of received transmission (Pilot
only).
control
Figure 19-8. Pilot VOLUME Control Panel
19-13 ORIGINAL
NAVAIR 01.Fl4AAD-1
TEST 680.000
TEST 465
TEST 061
TEST 651
TEST 157
TEST 333
FAULT INTERPRETATION
RMT or RT SELECT TEST MODE
LOW PWR SELECT TEST MODE
RMT CTRL DEFECTIVE CONTROL
NONE RT AND CTRL OK
RT MODULES 4,5, OR 6 SAD
VSWR RT OR ANTENNA SYSTEM
FWDPWR RT OR ANTENNA SYSTEM
I
RT MODULES 1,5, OR 7
I
RT MODULE 3 SAD
I
Figure 19-9. Common BIT Indications
1 .l 269.950 2.1 295.850 3.1 290.450 4.1 275.950 5.1 270.450 6.1 300.050
1.2 299.000 2.2 289.600 3.2 279.000 4.2 269.300 5.2 259.000 6.2 249.000
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：F-14D 飞行手册 Flight Manual 3
