曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
(see Figure 38-20) (note that block address terminates
automatically after its activation):
1. Select block address mode by pressing BLK
ADRS on CSS page of DEU.
2. Select system to be examined by pressing one of
equipment pushbuttons on B-ADRS page.
38-35 ORIGINAL
NAVAIR 01.Fl4AAD-1
MESSAGE (Note 1)
E FLYCH ADD {SSSS}
REASON FOR DISPLAY
Error in DEU entered flycatcher start address for the subsystem
identified in the {SSSS) field.
FLYCH EXISTS {SSSS} Only one flycatcher can be active per subsystem. The subsystem is
identified in the {SSSS} field. In order to setup the next flycatcher, the
previous flycatcher must be disabled.
E FLYCH INC {SSSS) Error in DEU entered flycatcher increment address for the subsystem
identified in the {SSSS} field.
N FLYCH IN {SSSS}
E FLYCH DEC (SSSS}
E NOT AVAIL
Error in DEU entry to increment, decrement or disable a flycatcher for
a subsystem that has no active flycatcher. The subsystem is identified
in the {SSSS} field.
Error in DEU entered flycatcher decrement address for the subsystem
identified in the {SSSS} field.
Flycatcher not available. System is not ready. JTIDS tape recording
(TOMs 21-27) enabled.
Note:
(1) {SSSS} identifies the affected CSS compatible subsystem.
Figure 38-19. Flycatcher Error Messages
3. Eater start address in hexadecimal with numeric
pushbuttons. Press ENT to complete the entry of
data aad to activate block addressm ode.
a. Press ALGO to select algorithm that is used to
trigger the capture of data. Eater algorithm
number with numeric keypads, sad press ENT
to complete this entry.
4. Repeat steps 2 and 3 for additional block address
operations for other systems. b. For each variable (i.e., Vl, V2, V3) ia selected
algorithm, press either an appropriate address
Trap is initiated or terminated as follows using tbe pushbutton (Vl ADRS, V2 ADRS, V3
DEU (see Figure 38-21). There is a maximum of four
traps per processor:
1. Select trap mode by pressing TRAP on CSS page
of DEU.
2. Select system to be examined by pressing one of
equipment pushbuttons on TRAP page.
3. Eater tmp number (00 to 98) where number caa
represent existing trap or new one (depending on
the desired function).
4. Set up trap algorithm as indicated below, or press
DSBL to disable existing trap:
ADRS), orcoastaatpushbuttoa (Vl CNST, V2
CNST, V3 CNST). Both selections require aumerit
entry defining address of variable or actual
constant to be used in evaluation of
algorithm. Eater value with numeric pushbuttons
sad then press ENT to complete entry.
c. Press DATA ADRS to allow entry of start addressf
or data.E ater addressv ia numeric pushbuttons,
and press ENT to complete entry.
d. Press COMP to complete the activation oftrap.
5. Repeat steps 2 through 4 to initiate or terminate
additional trap operations for other systems.
ORIGINAL 38-36
NAVAIR Q1-FUAAD-I
DEPRESS
SLK ADRS
OPTION KEY
-1
I
I
I
I
I
I
I
S-ADRS
S-ADRS
I DEPRESS
SUBSYSTEM
““‘9” KEY
Figure. 38-20. DEU Block Address Pages
38-37 ORIGINAL
NAVAIR 01.F14AAb1
DEPRESS
TRAP
OPTION KEY
;
t
I
I
I
I
I
A
I
I
I
I
I
I
I
I
I
I
L
I
L
DEPRESSSUBSYSTEM
OPTlO,N KEY
-
-
-
7
I
I
I
T
I
J
7
I
I
t
I
I
_I
Figure 38-21. DEU Trap Pages
ORIGINAL 38.38
NAVAIR 0%FI4AAD-I
MESSAGE (Note 1)
E BLOCK ADD {SSSS)
E TFIAP ADD {SSSS) {NN}
REASON FOR DISPLAY
Error in DEU entered block start address for the identified subsystem.
Error in DEU entered trap start address for the identlfled subsystem
and trap number.
E 4 TRAPS {SSSS} {NN} Current trap entry exceeds the maximum of 4 allowable traps per
subsystem.
E TRAP VAR {SSSS} {NN} Error in DEU entered trap variable address for the identified
subsystem and trap number.
E TRAP ALGO {SSSS} {NN} Error in DEU entered algorithm code for the identified subsystem and
trap number.
NO TRAP NO. {SSSS} {NN}
TRAP TRU IN (SSSS}
Error in DEU entered trap number that 1s selected to be disabled.
Trap in identified subsystem has been triggered. Contents of the
captured data block can be displayed on the CSS format.
Note:
(1) {SSSS} identiies the affected CSS compatible subsystem. {NN} identiies a trap number ranging
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
F-14D 飞行手册 Flight Manual 3(75)
