曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
Make sure that INT volume is turned up to permit contact with the ground crew.
VHF ..................................................................................................................................... CHECK
Check transmission and reception.
HF (if required for flight).........................................................................................................CHECK
‐ Check transmission and reception.
‐ Do not transmit on HF during refueling.
*WEATHER RADAR
* Power supply sw .......................................................................................................CHECK OFF
A318/A319/A320/A321 FLIGHT CREW
OPERATING MANUAL
PROCEDURES
NORMAL PROCEDURES
STANDARD OPERATING PROCEDURES - COCKPIT PREPARATION
A318/A319/A320/A321 FLEET PRO-NOR-SOP-06 P 8/22
FCOM 19 AUG 10
* WINDSHEAR switch .......................................................................................... CHECK OFF
* GAIN....................................................................................................................................AUTO
* MODE...........................................................................................................................AS RQRD
SWITCHING PANEL
SWITCHING panel................................................................................................................. CHECK
Check all selectors at NORM.
ECAM CONTROL PANEL
* STS pb..............................................................................................................................PRESS
Check that INOP SYS display is compatible with MEL.
If a message is displayed in MAINTENANCE STATUS, see PARKING procedure (Refer to
PRO-NOR-SOP-25-A Parking - General).
* PRESS pb...........................................................................................................................PRESS
Check that the CAB PRESS page displays LDG ELEV AUTO, to confirm the correct position of the
LDG ELEV knob.
COCKPIT DOOR
If required by local Airworthiness Authorities:
ANN LT selector....................................................................................................................... TEST
Check that the OPEN and FAULT lights (on the pedestal), and the three LED lights (on the
overhead panel) come on.
ANN LT sw................................................................................................................................ BRT
Check the lights go off.
CKPIT DOOR................................................................................CHECK CORRECT OPERATION
Set the COCKPIT DOOR sw to the UNLOCK position. Check that the ‐ door opens, and that the
OPEN light comes on
‐ Then, with the door fully open, release the COCKPIT DOOR sw (check that it returns to NORM
position). Close the door. Check that it is locked, and that the OPEN Indication goes off.
CKPIT DOOR MECHANICAL OVERRIDE............................................................................ CHECK
Check that the door opens normally, and that it closes when the mechanical override is used.
*ENG
* THRUST LEVERS ................................................................................................... CHECK IDLE
* ENG MASTER sw .................................................................................................... CHECK OFF
A318/A319/A320/A321 FLIGHT CREW
OPERATING MANUAL
PROCEDURES
NORMAL PROCEDURES
STANDARD OPERATING PROCEDURES - COCKPIT PREPARATION
A318/A319/A320/A321 FLEET PRO-NOR-SOP-06 P 9/22
FCOM 19 AUG 10
* ENG MODE selector..............................................................................................CHECK NORM
*PARKING BRK
* PARK BRK handle.................................................................................................ON THEN OFF
‐ Check pressure on the BRAKE PRESS.
‐ If chocks are in place, release the parking brake to increase brake cooling.
GRAVITY GEAR EXTN
GRAVITY GEAR EXTN....................................................................................... CHECK STOWED
ATC
ATC...............................................................................................................SET FOR OPERATION
Perform the appropriate ATC selection to allow the ATC transponder to operate in mode S Refer
to DSC-34-50-10 DESCRIPTION, TCAS is on standby. To prevent possible interference to radar
surveillance systems, TCAS should not be selected before the holding point/lining up.
ALT RPTG................................................................................................................................... ON
ATC SYS 1........................................................................................................................... SELECT
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
A320机组操作手册FLIGHT CREW OPERATING MANUAL 11(130)
