• 热门标签

当前位置: 主页 > 航空资料 > 国外资料 >

时间:2010-05-28 01:27来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

descent altitude, and coupled precision approaches
must be flown manually below 50 feet AGL.
Note:Coupled and autoland approaches are flown
in VFR and IFR. It is common for carriers to require
their crews to fly coupled approaches and autoland
approaches (if certified) when the weather
conditions are less than approximately 4,000 RVR.
(See AUTOLAND APPROACH.)
COURSEa.
The intended direction of flight in the horizontal
plane measured in degrees from north.
b. The ILS localizer signal pattern usually
specified as the front course or the back course.
Pilot/Controller Glossary 2/14/08
PCG C-8
c. The intended track along a straight, curved, or
segmented MLS path.
(See BEARING.)
(See INSTRUMENT LANDING SYSTEM.)
(See MICROWAVE LANDING SYSTEM.)
(See RADIAL.)
CPDLC-
(See CONTROLLER PILOT DATA LINK
COMMUNICATIONS.)
CPL [ICAO]-
(See ICAO term CURRENT FLIGHT PLAN.)
CRITICAL ENGINE- The engine which, upon
failure, would most adversely affect the performance
or handling qualities of an aircraft.
CROSS (FIX) AT (ALTITUDE)- Used by ATC
when a specific altitude restriction at a specified fix
is required.
CROSS (FIX) AT OR ABOVE (ALTITUDE)- Used
by ATC when an altitude restriction at a specified fix
is required. It does not prohibit the aircraft from
crossing the fix at a higher altitude than specified;
however, the higher altitude may not be one that will
violate a succeeding altitude restriction or altitude
assignment.
(See ALTITUDE RESTRICTION.)
(Refer to AIM.)
CROSS (FIX) AT OR BELOW (ALTITUDE)-
Used by ATC when a maximum crossing altitude at
a specific fix is required. It does not prohibit the
aircraft from crossing the fix at a lower altitude;
however, it must be at or above the minimum IFR
altitude.
(See ALTITUDE RESTRICTION.)
(See MINIMUM IFR ALTITUDES.)
(Refer to 14 CFR Part 91.)
CROSSWINDa.
When used concerning the traffic pattern, the
word means “crosswind leg.”
(See TRAFFIC PATTERN.)
b. When used concerning wind conditions, the
word means a wind not parallel to the runway or the
path of an aircraft.
(See CROSSWIND COMPONENT.)
CROSSWIND COMPONENT- The wind component
measured in knots at 90 degrees to the
longitudinal axis of the runway.
CRUISE- Used in an ATC clearance to authorize a
pilot to conduct flight at any altitude from the
minimum IFR altitude up to and including the
altitude specified in the clearance. The pilot may
level off at any intermediate altitude within this block
of airspace. Climb/descent within the block is to be
made at the discretion of the pilot. However, once the
pilot starts descent and verbally reports leaving an
altitude in the block, he/she may not return to that
altitude without additional ATC clearance. Further, it
is approval for the pilot to proceed to and make an
approach at destination airport and can be used in
conjunction with:
a. An airport clearance limit at locations with a
standard/special instrument approach procedure. The
CFRs require that if an instrument letdown to an
airport is necessary, the pilot shall make the letdown
in accordance with a standard/special instrument
approach procedure for that airport, or
b. An airport clearance limit at locations that are
within/below/outside controlled airspace and without
a standard/special instrument approach
procedure. Such a clearance is NOT AUTHORIZATION
for the pilot to descend under IFR conditions
below the applicable minimum IFR altitude nor does
it imply that ATC is exercising control over aircraft
in Class G airspace; however, it provides a means for
the aircraft to proceed to destination airport, descend,
and land in accordance with applicable CFRs
governing VFR flight operations. Also, this provides
search and rescue protection until such time as the
IFR flight plan is closed.
(See INSTRUMENT APPROACH
PROCEDURE.)
CRUISE CLIMB- A climb technique employed by
aircraft, usually at a constant power setting, resulting
in an increase of altitude as the aircraft weight
decreases.
CRUISING ALTITUDE- An altitude or flight level
maintained during en route level flight. This is a
constant altitude and should not be confused with a
cruise clearance.
(See ALTITUDE.)
(See ICAO term CRUISING LEVEL.)
CRUISING LEVEL-
(See CRUISING ALTITUDE.)
CRUISING LEVEL [ICAO]- A level maintained
during a significant portion of a flight.
2/14/08 Pilot/Controller Glossary
PCG C-9
CT MESSAGE- An EDCT time generated by the
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:航空信息手册附录(26)