A319/A320/A321
oniatTri
ABNORMAL PROCEDURES
REV 36
2.09
SEQ 001
A fuel leak may either be detected by :
. The fact that the sum of the FOB and the F USED is significantly less than the FOB at departure or decreases, or
. Passenger observation (fuel spray from engine or wing tip), or
. Total fuel quantity decreasing at an abnormal rate, or
. A fuel imbalance, or
. A tank emptying too fast (leak from engine, or a hole in a tank), or
. A tank overflowing (due to a pipe rupture in a tank), or
. An excessive fuel flow, (leak from engine), or
. A fuel smell in the cabin
If visibility permits, a visual check from the cabin may permit to identify the source of the leak.
WHEN A LEAK IS CONFIRMED
LAND ASAP
* LEAK FROM ENGINE :
* THR LEVER (of affected engine) IDLE
* ENG MASTER (of affected engine) OFF
* FUEL X FEED USE AS RQRD
The crossfeed valve can now be selected open for re-balancing, or to allow use of the fuel from both wings. Do not restart the engine.
* LEAK NOT FROM ENGINE or LEAK NOT LOCATED
* FUEL X FEED MAINTAIN CLOSED
The crossfeed valve must remain closed to prevent the leak from affecting both sides.
* DESCEND TO GRVTY FUEL FEEDING CEILING (FL 100 IF JET B) See the GRVTY FUEL FEEDING procedure.
* ENG MODE SEL IGN
* ALL TK PUMPS (when gravity ceiling is reached) OFF
In almost all cases, switching the pumps off will prevent any further loss of fuel. All pumps must be switched off, even if the leak is from one wing only, as there are some failures on one side that will result in fuel loss from the other side.
* AVOID NEGATIVE G FACTOR
CAUTION
Do not open the WING X-FEED, even if requested by another ECAM procedure.
Do not apply the fuel IMBALANCE procedure :
Even with a fuel imbalance of one wing full/one wing empty, there is no special procedure required for approach and landing
• If one engine flames out when there is still fuel in the feeding tank :
* LEAK FROM ENGINE proc APPLY
* ALL TK PUMPS ON
NOTE : The flameout is due to air suction from a leak from the engine.
I FOR LANDING
CAUTION
Notify the ATC, and do not use reverse.A319/A320/A321
oniatTri
ABNORMAL PROCEDURES
REV 34
2. 10
SEQ 001
* If icing conditions cannot be avoided :
* One of affected ADRs OFF
F/CTL ADR DISAGREE
* AFFECTED DU IS BLANK or DISPLAY IS DISTORTED :
* DU (affected) AS RQRD
The DU can be switched off.
* ECAM/ND XFR (if ECAM DUs affected) USE
Transfer SD to the F/O or CAPT ND.
* PFD/ND XFR (if EFIS DUs affected) USE
* DIAGONAL LINE ON THE AFFECTED DU :
* EIS DMC SWITCHING AS RQRD
* IF UNSUCCESSFUL : - DU (affected) OFF THEN ON
NOTE: ND display may disappear, in case too many waypoints and associated information are displayed. Reduce the range, or deselect WPT or CSTR, and the display will automatically recover after about 30 seconds.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A319/A320/A321 QUICK REFERENCE HAND BOOK(18)