• 热门标签

当前位置: 主页 > 航空资料 > 飞行资料 >

时间:2011-03-14 13:13来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

Verify dashes are displayed.
TAKEOFF REF page – Select
Verify preflight complete. Check displayed OAT against reported
value. Enter correct value if necessary.
Enter OAT and takeoff speeds.
If reduced thrust takeoff is planned, enter assumed (SEL) temperature and select the desired mode on the N1 limit page.
Note:  Verify N1 reference bugs reflect the full rated N1 value or the derated N1 value if a TAKEOFF DERATE is selected.
Takeoff data ................................................................................... Check

Verify takeoff data to include N1, V1, VR, V2, flap setting, zero fuel weight, temperature, altimeter setting, gross weight, and stabilizer trim setting.
Flight Deck Preparation – First Officer
Escape strap ................................................................................... Check

Ensure strap is connected to structure. Sun visor and smoke goggles .......................................................Stowed Oxygen and interphone.................................................................. Check
Audio selector panel – Set
Normal Procedures -Amplified Procedures 737 Operations Manual

Push FLT INT transmitter selector and receiver switch, and adjust volume controls on receiver switch and overhead speaker. Position microphone selector to MASK.
Oxygen panel – Set Check mask is properly stowed and NORMAL/100% switch is at 100%. RESET/TEST slide lever – Push down and hold Observe momentary yellow cross in flow indicator. EMERGENCY/TEST selector – Push and hold While holding RESET/TEST slide lever down, push EMERGENCY/TEST selector and observe constant yellow cross in flow indicator. Push–To–Talk switch – I/C While holding RESET/TEST slide lever down and pushing the EMERGENCY/TEST selector, simultaneously key microphone and listen for oxygen flow sound through the overhead speaker. Then release all switches and reposition microphone selector as desired. Oxygen pressure – Check Verify pressure meets dispatch requirements.
Audio Selector panel (as installed) ........................................................................................ Set Air conditioning system ................................... ____ pack(s), bleeds ON
AIR TEMPERATURE source selector – As desired
Temperature selectors – As desired
RAM DOOR FULL OPEN lights – Illuminated
RECIRCULATION FAN switch – AUTO
Air conditioning PACK switches – One AUTO or HIGH
ISOLATION VALVE switch – AUTO
Engine BLEED air switches – ON

Copyright . The Boeing Company. See title page for details.
NP.20.16  June 4, 2004

Normal Procedures -Amplified Procedures 737 Operations Manual
APU BLEED air switch – As required
ON unless external air is used for start.

Pressurization system ..........................................................................Set FLIGHT ALTITUDE indicator – Cruise altitude LANDING ALTITUDE indicator – Destination field elevation CABIN RATE selector – Index CABIN ALTITUDE indicator – 200 feet below destination field
elevation
FLT/GRD switch (as installed) – GRD
Pressurization mode selector – AUTO

 AUTOMATIC FAIL light – Extinguished
NAV switch (as installed) ..........................................................................As required Mode control panel ..............................................................................Set
When selecting a value on the MCP, ensure the corresponding display on the instrument panel changes, if applicable.
COURSE(S) – Set and crosscheck FLIGHT DIRECTOR switches – ON Position the switch for the pilot flying to ON first. Air temp/True airspeed indicator (as installed) ............................. Check
Select TAT. Right flight instruments .......................................................................Set Note: IRS alignment must be complete.
EFIS – Correct
A/T, Pitch and ROLL FMA’s - Blank
A/P STATUS FMA - FD
Flight instrument indications are correct.

Normal Procedures -Amplified Procedures 737 Operations Manual

Verify no flags displayed.
Altimeter - Set
MAP – Correct
Verify no flags displayed.
Route - Displayed, correct.

Clock ................................................................................................... Set GROUND PROXIMITY warning SYSTEM
TEST switch ...............................................................Push momentarily Verify switch guards down. Verify proper operation of the following:
.
BELOW G/S, GPWS INOP and TERRAIN DISPLAY SELECT lights illuminate

.
 PULL UP and WINDSHEAR alerts illuminate

.
“GLIDESLOPE,” “PULL UP,” “WINDSHEAR,” “TERRAIN, TERRAIN PULL UP,” “OBSTACLE, OBSTACLE PULL UP,” aurals sound
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:737-300机组操作手册Flight Crew Operations Manual FCOM 1(37)