曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
Before attempting to taxi the airplane, ground personnel should be
instructed and authorized by the owner to taxi the airplane. Instruction
should include engine starting and shutdown procedures in addition to
taxi and steering techniques.
• Caution •
Verify that taxi and propeller wash areas are clear before
beginning taxi.
Do not operate the engine at high RPM when running up or
taxiing over ground containing loose stones, gravel, or any
loose material that may cause damage to the propeller blades.
Taxi with minimum power needed for forward movement.
Excessive braking may result in overheated or damaged
brakes.
1. Remove chocks.
2. Start engine in accordance with Starting Engine procedure
(Section 4).
3. Release parking brake.
4. Advance throttle to initiate taxi. Immediately after initiating taxi,
apply the brakes to determine their effectiveness. During taxiing,
use differential braking to make slight turns to ascertain steering
effectiveness.
• Caution •
Observe wing clearance when taxiing near buildings or other
stationary objects. If possible, station an observer outside the
airplane.
Avoid holes and ruts when taxiing over uneven ground.
5. Taxi airplane to desired location.
6. Shut down airplane and install chocks and tie-downs in
accordance with Shutdown procedure (Section 4).
March 2010
Information Manual 8-13
Cirrus Design Section 8
SR20 Handling, Servicing, Maintenance
Parking
The airplane should be parked to protect the airplane from weather
and to prevent it from becoming a hazard to other aircraft. The parking
brake may release or exert excessive pressure because of heat
buildup after heavy braking or during wide temperature swings.
Therefore, if the airplane is to be left unattended or is to be left
overnight, chock and tie down the airplane.
1. For parking, head airplane into the wind if possible.
2. Retract flaps.
3. Set parking brake by first applying brake pressure using the toe
brakes and then pulling the PARK BRAKE knob aft.
• Caution •
Care should be taken when setting overheated brakes or
during cold weather when accumulated moisture may freeze a
brake.
4. Chock both main gear wheels.
5. Tie down airplane in accordance with tiedown procedure in this
section.
6. Install a pitot head cover. Be sure to remove the pitot head cover
before flight.
7. Cabin and baggage doors should be locked when the airplane is
unattended.
March 2010
8-14 Information Manual
Section 8 Cirrus Design
Handling, Servicing, Maintenance SR20
Tiedown
The airplane should be moored for immovability, security and
protection. FAA Advisory Circular AC 20-35C, Tiedown Sense,
contains additional information regarding preparation for severe
weather, tiedown, and related information. The following procedures
should be used for the proper mooring of the airplane:
1. Head the airplane into the wind if possible.
2. Retract the flaps.
3. Chock the wheels.
4. Secure tie-down ropes to the wing tie-down rings and to the tail
ring at approximately 45-degree angles to the ground. When using
rope or non-synthetic material, leave sufficient slack to avoid
damage to the airplane should the ropes contract.
• Caution •
Anchor points for wing tiedowns should not be more than 18
feet apart to prevent eyebolt damage in heavy winds.
Use bowline knots, square knots, or locked slipknots. Do not
use plain slipknots.
Leveling
The airplane is leveled longitudinally by means of a spirit level placed
on the pilot door sill and laterally by means of a spirit level placed
across the door sills. Alternately, sight the forward and aft tool holes
along waterline 95.9 to level airplane. Refer to Section 6, Airplane
Weighing Procedures and Section 6, Figure 6-2, for illustration.
March 2010
Information Manual 8-15
Cirrus Design Section 8
SR20 Handling, Servicing, Maintenance
Jacking
Two jacking points are provided: one at each wing tiedown. Jack points
(pads) are stowed in the baggage compartment. The airplane may be
jacked using two standard aircraft hydraulic jacks at the wing jacking
points and a weighted tailstand attached to the tail tiedown.
Raise Airplane
• Caution •
Do not jack the aircraft outside or in open hangar with winds in
excess of 10 mph.
The empty CG is forward of the wing jacking points. To prevent
airplane from tipping forward during maintenance or jacking,
use a weighted tailstand (300-lb minimum) attached to the tail
tiedown.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
西锐20飞机信息手册 SR22 AIRPLANE INFORMATION MANUAL 1148-126(83)
