• 热门标签

当前位置: 主页 > 航空资料 > 飞行资料 >

时间:2010-09-26 10:42来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

1 and the copilot’s side displays ADC 2. Refer to GARMIN G1000 Cockpit Reference
Guide for additional information.
1. Either PFD SENSOR softkey - - - - - - - - - - - - - - - - - - - - - - - - - - - PRESS
2. PFD ADC1/2 softkey - - - - - - - - - - - - - - - - - - - - - SELECT ON-SIDE ADC
(ADC1 for Pilot PFD, ADC2 for copilot PFD)
3. PFD Displays - - - - - - - - - - - - - - - - - - CONFIRM “BOTH ON ADC 1 or 2"
message displays on both PFDs
4. Repeat procedure on opposite PFD.
5. PFD Displays - - - - - - - - - - - - - - - - - - CONFIRM “BOTH ON ADC 1 or 2"
message clears on both PFDs
PROCEDURE COMPLETED
This message is displayed on both PFDs and indicates that both PFDs are displaying
data from the opposite side Attitude Heading Reference System. Normally the pilot’s
side displays AHRS 1 and the copilot’s side displays AHRS 2. Refer to GARMIN
G1000 Cockpit Reference Guide for additional information.
1. Either PFD SENSOR softkey - - - - - - - - - - - - - - - - - - - - - - - - - - - PRESS
2. PFD AHRS 1/2 softkey - - - - - - - - - - - - - - - - - - SELECT ON-SIDE AHRS
(AHRS1 for Pilot PFD, AHRS2 for Copilot PFD)
3. PFD Displays - - - - - - - - - - - - - - - - - CONFIRM “BOTH ON AHRS 1 or 2"
message displays on both PFDs
4. Repeat procedure on opposite PFD.
5. PFD Displays - - - - - - - - - - - - - - - - - CONFIRM “BOTH ON AHRS 1 or 2"
message clears on both PFDs
PROCEDURE COMPLETED
1. AFCS Circuit Breaker - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - CHECK
(L circuit breaker panel)
• IF STILL INOPERATIVE
2. ALTITUDE - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -FL300 Maximum
PROCEDURE COMPLETED
1  USING ADC
2  USING AHRS
3  YAW DAMPER INOPERATIVE
72 AJ 510CLEAP-07
X
Configuration
MODEL 510 EMERGENCY/ABNORMAL PROCEDURES
This message is displayed on both PFDs and indicates that both pilot and copilot PFDs
are displaying data from the same Air Data Computer. Normally the pilot’s side
displays ADC 1 and the copilot’s side displays ADC 2. Refer to GARMIN G1000
Cockpit Reference Guide for additional information.
1. PFD SENSOR softkey- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -PRESS
on PFD displaying data from opposite side ADC
2. PFD ADC1/2 softkey - - - - - - - - - - - - - - - - - - - - - SELECT ON-SIDE ADC
(ADC1 for Pilot PFD, ADC2 for copilot PFD)
3. PFD Displays - - - - - - - - - - - - - - - - - - CONFIRM “BOTH ON ADC 1 or 2"
message clears on both PFDs
PROCEDURE COMPLETED
This message is displayed on both PFDs and indicates that both pilot and copilot PFDs
are displaying data from the same Attitude Heading Reference System. Normally the
pilot’s side displays AHRS 1 and the copilot’s side displays AHRS 2. Refer to GARMIN
G1000 Cockpit Reference Guide for additional information.
1. PFD SENSOR softkey- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -PRESS
on PFD displaying data from opposite side AHRS
2. PFD AHRS1/2 softkey - - - - - - - - - - - - - - - - - - - SELECT ON-SIDE AHRS
(AHRS1 for Pilot PFD, AHRS2 for copilot PFD)
3 PFD Displays - - - - - - - - - - - - - - - - - CONFIRM “BOTH ON AHRS 1 or 2"
message clears on both PFDs
PROCEDURE COMPLETED
This message is displayed on both PFDs and indicates that both pilot and copilot PFDs
are displaying data from the same GPS receiver. Normally the pilot’s side displays
GPS 1 and the copilot’s side displays GPS 2 and is not pilot selectable. This may be
caused by operation outside of WAAS satellite coverage in which case the nonselected
GPS is still available in the event the active GPS fails. Refer to GARMIN
G1000 Cockpit Reference Guide for additional information.
1. GPS Status - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - CHECK
a. Select MFD AUX-GPS STATUS page.
b. Select GPS1 then GPS2 softkeys and verify sufficient
satellite reception.
PROCEDURE COMPLETED
3  BOTH ON ADC 1/2
4  BOTH ON AHRS 1/2
5  BOTH GPS 1/2
510CLEAP-07 AA 71
W
Configuration
EMERGENCY/ABNORMAL PROCEDURES MODEL 510
This message is displayed on both PFDs and indicates that both PFDs are displaying
data from the opposite side Air Data Computer. Normally the pilot’s side displays ADC
1 and the copilot’s side displays ADC 2. Refer to GARMIN G1000 Cockpit Reference
Guide for additional information.
1. Either PFD SENSOR softkey - - - - - - - - - - - - - - - - - - - - - - - - - - - PRESS
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:Citation Mustang checklist EMERGENCY/ABNORMAL PROCEDURES(37)