曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
Garmin G1000 Cockpit Reference Guide for the Cessna Citation Mustang 190-00600-02 Rev. A 6
EI
CAS
Flight
Instruments
EICAS
Nav/Com/
XPDR/Audio
AFCS
GPS Nav
Flight
Planning
Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/Alerts
Appendix
Index
Crew Alerting System (CAS) NOTE: Refer to the Annunciations and Alerts section for specific CAS messages. NOTE: Refer to the Airplane Flight Manual (AFM) for emergency procedures. NOTE: If there is a mismatch between databases or software on the PFDs, CAS is inoperative.
When CAS messages are present while in reversionary mode, the CAS Window appears on the display along with the flight instruments and EIS.
CAS MessagesReversionary ModeNormal ModeCAS WindowCAS Display
CAS Messages and Prioritization NOTE: Information on CAS messages in this pilot’s guide is always superseded by the AFM.
• Warning (red) – Immediate crew awareness and action required; Master Warning triggered
• Caution (yellow) – Immediate crew awareness and possible future corrective action required; Master Caution triggered
• Advisory (white) – Crew awareness required and subsequent action may be required
190-00600-02 Rev. A Garmin G1000 Cockpit Reference Guide for the Cessna Citation Mustang 7
N
av/Com/XPDR/Audio Panel
Flight
Instruments
EICAS
Nav/Com/
XPDR/Audio
AFCS
GPS Nav
Flight
Planning
Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/Alerts
Appendix
Index
v/Com/Transponder/Audio PaPanel
E
nter or Change Flight ID
1) Press the TMR/REF Softkey, then turn the large FMS Knob to highlight the Flight ID field.
2) Turn the small FMS Knob to enter the first character.
3) Turn the large FMS Knob to select the next field.
4) Turn the small FMS Knob to enter the next desired character.
5) Repeat steps 3 and 4 until the desired Flight ID is entered.
6) Press the ENT Key. In the FLT ID field, ‘updating’ is momentarily displayed. Do not perform any other G1000 functions until ‘updating’ is no longer displayed.
ADF Tuning (Optional)
1) Press the ADF/DME Softkey.
2) Turn the small FMS Knob to enter the first digit of the desired ADF frequency.
3) Turn the large FMS Knob to select the next desired field.
4) Turn the small FMS Knob to enter the desired number.
5) Repeat steps 3 and 4 until the desired ADF frequency is entered.
6) Press the ENT Key to accept the new frequency.
7) Press the ENT Key again to transfer the frequency to the active field.
8) Turn the large FMS Knob to select the MODE field.
9) Turn the small FMS Knob to select ANT, ADF, ADF/BFO, or ANT/BFO.
10) Press the ENT Key to complete the selection.
DME
Tuning
1) Press the ADF/DME or DME Softkey.
2) Turn the large FMS to select the DME source field.
3) Turn the small FMS Knob to select the desired Nav radio.
4) Press the ENT Key to complete the selection.
Garmin G1000 Cockpit Reference Guide for the Cessna Citation Mustang 190-00600-02 Rev. A 8
N
av/Com/XPDR/Audio Panel
Flight
Instruments
EICAS
Nav/Com/
XPDR/Audio
AFCS
GPS Nav
Flight
Planning
Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/Alerts
Appendix
Index
nter a Transponder Code
1) Press the XPDR Softkey to display the transponder mode selection softkeys.
2) Press the XPDR1 or XPDR2 Softkey to select the active transponder.
3) Press the CODE Softkey to display the transponder code selection softkeys, for digit entry.
4) Press the digit softkeys to enter the code in the code field. When entering the code, the next key in sequence must be pressed within 10 seconds, or the entry is cancelled and restored to the previous code. Five seconds after the fourth digit has been entered, the transponder code becomes active.
S
electing a COM Radio
T
ransmit/Receive
Press the COM1 MIC, COM2 MIC, or COM3 MIC Key (HF, if installed) on the audio panel.
R
eceive Only
Press the COM1, COM2, or COM3 Key (HF, if installed) on the audio panel.
S
electing a NAV Radio
1) Press the CDI Softkey to select NAV1 (VOR1/LOC1) or NAV2 (VOR2/LOC2).
2) Pressing the NAV1, NAV2, DME, or ADF Key on the audio panel selects and deselects the navigation radio audio source. All radio keys can be selected individually or together.
N
AV/COM Tuning
1) Press the small tuning knob to select the desired radio for tuning. A light blue box highlights the radio frequency to be tuned.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
Cockpit Reference Guide for the Cessna Citation Mustang(7)
