曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
FCC SAVE COMPLETE
FCC SAVE FAIL
DTC FORMAT INVALID
WPTS AUTOLOAD FAIL
TGTS AUTOLOAD FAIL
CODES AUTOLOAD FAIL
PPOS AUTOLOAD FAIL
DTC BATTERY LOW
DNS/HSI NAV CUES ??
Lines 5 - 8. - Displays the AND Missile status displays
(read vertically):
Cols. 3 & 4 show the LH Outbd pylon missile status
MEANING
FCC EEPROM TO RAM LOAD CHECKSUM ERROR
FCC EEPROM TO RAM LOAD CHECKSUM ERROR
FCC RAM TO EEPROM SUCCESSFUL
FCC RAM TO EEPROM SAVE CHECKSUM ERROR
DTC FILE FORMAT INVALID (DTC IS NOT USEABLE)
INVALID WPT CHECKSUM (WPT SAVE DATA INVALID)
INVALID TGT CHECKSUM (TGT SAVE DATA INVALID)
INVALID CODES CHECKSUM (CODES SAVE DATA INVALID)
INVALID PPOS CHECKSUM (PPOS SAVE DATA INVALID)
DTC BATTERY INDICATES LOW VOLTAGE
DNS FLY-TO DATA VALIDATION (WRAP) ERROR
Change 4 3-64.25
TM 1-1520-238-10
Figure 3-25.23. EXTENDED ADVISORY
MESSAGE
Table 3-22.18. EXTENDED ADVISORY
MESSAGES
CPU Fault
ROM Fault
RAM Fault
50 Hz Interrupt Fault
Interrupt Mask Fault
Program Lost Fault
RAM Overwrite Fault
Watchdog Timeout Fault
3.16.14 Pilot High Action Display (HAD) The Pilot
HAD Sight Status and Weapon Status fields have been
modified to allow display of Distance-To-Go and Time-
To-Go (figure 3-25.24) to the current FLY-TO destination
and the active fly-to symbol.. The new Sight Status
and Weapon Status Field prompts replace the
existing, lowest priority displays. The new displays are
out-prioritized by all other HAD displays.
Figure 3-25.24. PILOT HIGH ACTION
DISPLAY (HAD)
a. Sight Status Field. The Sight Status Field is modified
to provide Distance-To-Go from PPOS to the selected
FLY-To location. Character space 1 and 2 are
blank. Character spaces 3 to 8 provide the Distance-
To-Go, with a colon in space 6 (providing 100 meter resolution
to the pilot) and a K or N (Kilometers or Nautical
miles) in space 8 . Units are selectable by the CPG
using the CDU. All numerals in this display are refreshed
at 1Hz.
b. Weapon Status Field. The Weapon Status Field
provides, as its three lowest priorities prompts, HSI
CUE?, Time-To-Go (TTG) from PPOS to the selected
FLY-TO and the active fly - to symbol. The HSI CUE?
is the highest priority and is the same indication to the
pilot as the advisory message DNS/HSI NAV CUES ??
is to the CPG. It is removed from the pilot weapon status
display when the CPG clears the Advisory message.
The TTG display is the lowest priority and is in hours
and minutes (H:MM) if the TTG is greater than 5 minutes.
This display changes to minutes and seconds
(M:SS) when TTG is less than 5 minutes. The first
character space will be H (Hours) or M (minutes). The
second character space is a colon (:). The third and
fourth character spaces will be either MM (minute values
00 to 59) or SS second values 00 to 59). The fifth,
sixth and seventh character spaces will display the flyto
symbol (W0l through T80) The eighth character
space is blank. All characters relating to TTG become
dashed when the TTG is greater than 9 hours and 59
minutes or the ground speed is less than 10 KTS.
c. Trim Ball. The trim ball will flash when the
HARS has been free inertial for 20 seconds or more, and
aircraft groundspeed is less than 10 knots.
3-64.26 Change 4
TM 1-1520-238-10
Change 6 3-64.27/(3-64.28 blank)
3.16.15 Co--Pilot Gunner High Action Display (HAD)
The CPG HAD (figure 3-25.25) has been modified to
provide an Active Target Number in the Sight Status
Field and an ORT STORE prompt in the Weapon Status
Field. This information will be displayed unless other
Sight Status andWeapon Statusmessages outprioritize
it.
M01--0352
T41 STR T71
Figure 3-25.25. CPG HIGH ACTION DISPLAY
(HAD)
a. Sight Status Field. The Sight Status Field is modified
to provide an indication of the Active Target
Number. Character spaces 1 thru 3 are blank. Character
space 4 will be a T orWindicating the Active Target
is in either the Target or Waypoint List. Character
space 5 and 6 will be a number from 01--80 indicating
the location within the TGT/WPT List. Character
spaces 7 and 8 are blank.
b. Weapon Status Field. The Weapon Status Field
is modified to provide the ORT STORE prompt. The
ORT STORE prompt is formatted as follows: STR
TXX. XX is a number from 71--80 to designate which
location in the TGT List has received the new coordinate
data. The ORT STORE prompt will be displayed
for a duration of 2 seconds and will then be removed.
STR will be located in character spaces 1--3. Character
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
阿帕奇攻击直升机操作手册1(127)
