曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
Read-Only. The AND page is shown in figure
and discussed below. VAB functions are inactive. To
return to PGM MENU top level page, depress the PGM
FAB.
3-64.24 Change 3
23
TM 1-1520-238-10
Figure 3-26.22. ALPHANUMERIC DISPLAY
Page Line 1. Left-hand character field displays the AND
Sight Status Field. Right-hand character field displays
the AND Weapon Status Field.
Line 2. Displays the AND TADS Status Field.
Line 3. Displays the AND LST/RFD Status Field.
Line 4. Displays the AND Missile Enhancement Display
Field.
Lines 5 8. Displays the AND Missile status displays (read
vertically):
Cols. 3 & 4 show the LH Outbd pylon missile status
Cols. 7 & 8 show the LH Inbd pylon missile status
Cols. 15 & 16 show the RH Inbd pylon missile status
Cols. 19 & 20 show the RH Outbd pylon missile status
3.16.13. Pilot High Action Display (HAD) The Pilot
HAD Sight Status and Weapon Status fields have been
modified to allow display of Distance-To-Go and TimeTo-
Go (figure 3-26.23) to the current FLY-TO destination
and the active fly-to symbol.. The new Sight St tus and
Weapon Status Field prompts replace the existing,
lowest priority displays. The new displays are outprioritized
by all other HAD displays.
Figure 3-26.23. PILOT HIGH ACTION DISPLAY
(HAD)
a. Sight Status Field. The Sight Status Field is modified
to provide Distance-To-Go from PPOS to the selected
FLY-To location. Character space 1 and 2 are blank.
Character spaces 3 to 8 provide the DistanceTo-Go, with
a colon in space 6 (providing 100 meter resolution to the
pilot) and a K or N (Kilometers or Nautical miles) in
space 8 . Units are selectable by the CPG using the
CDU. All numerals in this display are refreshed at 1Hz.
b. Weapon Status Field. The Weapon Status Field
provides, as its three lowest priorities prompts, HSI
CUE?, Time-To-Go (TTG) from PPOS to the selected
FLY-TO and the active fly_ to symbol. The HSI CUE? is
the highest priority and is the same indication to the pilot
as the advisory message DNS/HSI NAV CUES ?? is to
the CPG. It is removed from the pilot weapon status
display when the CPG clears the Advisory message. The
TTG display is the lowest priority and is in hours and
minutes (H: MM) if the TTG is greater than 5 minutes.
This display changes to minutes and seconds when TTG
is less than 5 minutes. The first character space will be H
(Hours) or M (minutes). The second character space is a
colon (: ). The third and fourth character spaces will be
either MM (minute values 00 to 59) or SS second values
00 to 59). The fifth, sixth and seventh character spaces
will display the fly to symbol (W01 through T80) The
eighth character space is blank. All characters relating to
TTG become dashed when the TTG is greater than 9
hours and 59 minutes or the ground speed is less than
10 KTS.
c. Trim Ball. The trim ball will flash when the HARS has
been free inertial for 20 seconds or more, and aircraft
ground speed is less than 10 knots.
Change 3 3-64.25
24
TM.1-1520-238-10
3.16.14 Co-Pilot Gunner High Action Display (HAD)
The CPG HAD (figure 3-26.24) has been modified to
provide an Active Target Number in the Sight Status
Field and an ORT STORE prompt in the Weapon Status
Field. This information will be displayed unless other
Sight Status and Weapon Status messages out prioritize
it.
Figure 3-26.24. CPG HIGH ACTION DISPLAY (HAD)
a. Sight Status Field. The Sight Status Field is modified
to provide an indication of the Active Target Number.
Character spaces 1 thru 3 are blank. Character space 4
will be a T or W indicating the Active Target is in either
the Target or Waypoint List. Character space 5 and 6 will
be a number from 01-80 indicating the location within the
TGT/WPT List. Character spaces 7 and 8 are blank.
b. Weapon Status Field. The Weapon Status Field is
modified to provide the ORT STORE prompt. The ORT
STORE prompt is formatted as follows: STR TXX. XX is
a number from 71-80 to designate which location in the
TGT List has received the new coordinate data. The
ORT STORE prompt will be displayed for a duration of 2
seconds and will then be removed. STR will be located in
character spaces 1-3. Character space 4 is blank.
Character space 5 will be a T. Character spaces 6 and 7
will contain the numbers from 71 to Character space 8 is
blank.
3.16 15 Horizontal Situation Indicator (HSI).
The HSI, (fig 3-26.25), on the pilot instrument panel is an
electromechanical indicator that presents position
information in relation to various navigational inputs.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
阿帕奇攻击直升机操作手册1(113)
