Forward Airstair Door Lubrication 580
12-25-111 Page 202 Figure 201 (Sheet 1) BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. Jun 20/89
580 Forward Airstair Door Lubrication
May 01/01 Figure 201 (Sheet 2) BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 12-25-111 Page 203
Forward Airstair Door Lubrication 580
12-25-111 Page 204 Figure 201 (Sheet 3) BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. Jun 20/89
581 Forward Airstair Door Lubrication
May 01/01 Figure 201 (Sheet 4) BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 12-25-111 Page 205
ELECTRONIC EQUIPMENT COMPARTMENT EXTERNAL ACCESS DOOR LUBRICATION
1. General
A. This procedure provides instructions for lubricating the electronic equipment compartment external access door.
2. Equipment and Materials
A. Grease - BMS 3-33, preferred (Ref. 20-30-21)
B. Grease - MIL-G-23827, alternate (Ref 20-30-21)
3. Lubricate Electronic Equipment Compartment External Access Door
A. Open electronic equipment compartment external access door.
B. Remove the center panel located on top of door to gain access to the rack assembly.
C. Lubricate electronic equipment compartment external access door as shown (Fig. 201).
D. Replace the center panel over rack assembly.
E. Close electronic equipment compartment external access door.
580
May 01/01 BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 12-25-121 Page 201
Electronic Equipment Compartment External Access Door Lubrication 580
12-25-121 Figure 201 (Sheet 1) May 01/01
Page 202
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.
580 Electronic Equipment Compartment External Access Door Lubrication
May 01/01 Figure 201 (Sheet 2) 12-25-121
Page 203
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.
LANDING GEAR SUPPORT BEAM LUBRICATION - MAINTENANCE PRACTICES CABLE LUBRICATION
5C9 Landing Gear Support Beam Lubrication
May 01/01 Figure 201 12-25-131
Page 201
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.
1. Equipment and Materials
A. Grease -BMS 3-33, preferred (Ref. 20-30-21)
B. Grease -BMS 3-24, alternate (Ref 20-30-21)
2. Lubrication Procedure
A. Remove the previously applied lubricant and any foreign matter from the surface of control cable for the full length of travel through fairleads, air pressure seals, over pulleys, quadrants, and drums with a dry lint-free cloth.
CAUTION: DO NOT USE SOLVENT OR HEAT TO THIN GREASE. DO NOT USE SOLVENT TO CLEAN CABLES, SINCE SOLVENT DILUTES AND REMOVES GREASE FROM INSIDE CABLE STRANDS. DO NOT APPLY OR SPRAY BMS 3-23 ON CONTROL CABLES.
B. Lubricate Cables
(1) Carbon Steel Cables
(a) Coat full length of cable (except through fair leads air pressure seals, over pulleys, quadrants and drums) with a minimum quantity of BMS 3-33 grease sufficient only to produce a continuous, thin, visible fillet of grease in cable grooves.
CAUTION: THROTTLE CABLES IN ENGINE AREA ARE IN A HIGH TEMPERATURE ENVIRONMENT, AND LUBRICATION MAY DETERIORATE MORE RAPIDLY THAN ON OTHER CABLE INSTALLATIONS. CHECK CABLE LUBRICATION CONDITION IN ENGINE AREA AT MORE FREQUENT INTERVALS.
(2) Stainless Steel Cables (CRES)
(a)
Do not apply cleaning solvents on control cables.
(b)
Do not apply grease or oil on control cables.
501
May 01/01 B
O
E
I
NG
P
R
OP
R
I
E
T
A
R
Y
- Copyri
ght
. - Unpubl
i
s
hed
W
o
r
k
-
S
ee
t
i
t
l
e page f
o
r de
t
a
i
l
s
.
12-26-0 Page 201
508 Reverse Thrust Lever Lubrication
Sep 20/81 Figure 201 BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 12-27-21 Page 201
Engine Push-Pull Cable Lubrication 508
12-27-21 Figure 201 (Sheet 2) Feb 15/77
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737 AMM 飞机维护手册 SERVICING(47)
