曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
(2) Adjust the lumbar in / out support and up / down support to the out
and down positions.
(3) Adjust the recline angle to approximately mid-position.
(4) Adjust the back cushion to approximately mid-position.
OPERATING MANUAL
PRODUCTION AIRCRAFT SYSTEMS 2A-06-00
Page 19
May 30/02
Revision 7
(5) Ensure the occupant is correctly positioned in the seat pan.
(6) Adjust the recline angle until the shoulders are positioned at the
desired sitting angle.
(7) Adjust the lumbar in / out support and up / down support to the
desired positions.
(8) Using the vertical adjustment control and fore / aft track lock control,
position the seat to properly align the occupant with the Design Eye
Locator on the center windshield post.
(9) Verify thigh pads “break away” to allow sufficient movement on the
rudder pedals and toe brakes.
6. Standard Aircraft Equipment and Furnishings:
The equipment listed in the following tables is supplied as standard equipment on
each aircraft:
AIR CONDITIONING
Quantity Nomenclature
1 APU Exhaust Plug
1 Anti-Ice Discharge Port Cover
1 LH Ram Air Scoop Plug
1 RH Ram Air Scoop Plug
1 Outflow Valve / Safety Valve Cover
1 LH Ram Air Exhaust Port Cover
1 RH Ram Air Exhaust Port Cover
1 Tail Compartment Vent Cover
ELECTRICAL
Quantity Nomenclature
1 AC / DC Electrical Load Analysis
2 Battery Cell Cap Remover
FURNISHINGS
Quantity Nomenclature
3 Pitot Tube Cover
2 Flashlight
2 Rechargeable Maglite (Cockpit / Baggage Compartment)
(1)
2 Logo Button
2 Airstair Door Emblem
4 Static Port Cover
4 Oxygen Cylinder Cushion, Clamp and Nut
NOTE(S):
(1) SN 1462 and subs.
FURNISHINGS
Quantity Nomenclature
2 Fuel Vent Screen Assembly
OPERATING MANUAL
2A-06-00 PRODUCTION AIRCRAFT SYSTEMS
Page 20
May 30/02
Revision 7
FURNISHINGS
Quantity Nomenclature
2 Engine Intake Cowling Cover
2 Engine Exhaust Reverser Doors Cover
2 Upper Cowl Inlet Scoop Plug
2 NAC Air Inlet Cover
2 NAC Air Outlet Cover
2 Generator Air Exhaust Plug
2 Low Pressure Cooling Exhaust Plug
2 Generator Air Inlet Plug
2 Pylon Outlet Cover
2 Pylon Air Inlet Plug
1 Exhaust Louver Covers Assembly
PRODUCT SUPPORT
Quantity Nomenclature
1 Nose Wheel Door Ground Safety Strut
2 Main Landing Gear Safety Lock
2 Main Landing Gear Door Safety Valve Lock
1 Nose Landing Gear Safety Lock
1 Nose Landing Gear Door Safety Valve Lock
2 Smoke Goggles
PUBLICATIONS
Quantity Nomenclature
1 Weight and Balance Report
2 Engine Log Book
1 Airplane Log Book
1 Aeronautical Equipment Service Record
1 Maintenance Manual
1 Wiring Diagram Manual
1 Illustrated Parts Catalogue
1 Airplane Flight Manual
1 Oxygen System Report
1 Soundproofing Report
STRUCTURES
Quantity Nomenclature
7 Cabin Floor Blowout Cover
HYDRAULICS
Quantity Nomenclature
3 Hydraulic Fluid Sample Kit
OPERATING MANUAL
PRODUCTION AIRCRAFT SYSTEMS 2A-06-00
Page 21
May 30/02
Revision 7
Cockpit Areas
Figure 10
OPERATING MANUAL
2A-06-00 PRODUCTION AIRCRAFT SYSTEMS
Page 22
May 30/02
Revision 7
Overhead Panel / Circuit Breaker Panels
Figure 11
OPERATING MANUAL
PRODUCTION AIRCRAFT SYSTEMS 2A-06-00
Page 23
May 30/02
Revision 7
Pilot Flight Panel
Figure 12
OPERATING MANUAL
2A-06-00 PRODUCTION AIRCRAFT SYSTEMS
Page 24
May 30/02
Revision 7
Center Flight Panel
Figure 13
OPERATING MANUAL
PRODUCTION AIRCRAFT SYSTEMS 2A-06-00
Page 25
May 30/02
Revision 7
Copilot Flight Panel
Figure 14
OPERATING MANUAL
2A-06-00 PRODUCTION AIRCRAFT SYSTEMS
Page 26
May 30/02
Revision 7
Pilot Side Console
Figure 15
OPERATING MANUAL
PRODUCTION AIRCRAFT SYSTEMS 2A-06-00
Page 27
May 30/02
Revision 7
OPERATING MANUAL
THIS PAGE IS INTENTIONALLY LEFT BLANK.
2A-06-00 PRODUCTION AIRCRAFT SYSTEMS
Page 28
May 30/02
Center Pedestal
Figure 16
OPERATING MANUAL
2A-06-00
Page 29 / 30
May 30/02
Copilot Side Console
Figure 17
OPERATING MANUAL
PRODUCTION AIRCRAFT SYSTEMS 2A-06-00
Page 31
May 30/02
Revision 7
Pilot / Copilot Aft Circuit Breaker Panels
Figure 18
OPERATING MANUAL
2A-06-00 PRODUCTION AIRCRAFT SYSTEMS
Page 32
May 30/02
Revision 7
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
湾流4操作手册 Gulfstream IV Operating Manual 1(35)
