• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2010-05-01 10:13来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

in compliance with ARINC 429.
This message can be received by the port A or the port
B of the transceiver. The RMP performs the selection
by a discrete.
The message can be made up of a one word of 32 bits
or two words of 32 bits for the 100 Hz spacing or CW
mode. A microprocessor performs the decoding of the
frequency and mode ( AM or USB ).
The microprocessor, inside the HF transceiver, checks
the message from the Radio Management Panel and
controls the system operation. In case of failure it
controls the illumination of the lights located on the
face of the transceiver and is recorded in the BITE
memory.
SDAC
The connection between the HF transceiver and the
System Data Acquisition Concentrator ( SDAC ) enables
the use of the HF system in transmission mode to be
recorded .
The connection is obtained through the PTT switch.
In case of continuous emitting during more than one
minute, the ECAM displays in amber:
COM: HF 1 EMITTING
AMU
The HF system is linked to the Audio Management Unit
for connection to the audio integrating and SELective
CALling (SELCAL) system.
The Audio Control Panels (ACPs) are used for HF
transmission or reception selection mode and control
of the received audio signal levels through the AMU.
LGCIU
The Landing Gear Control and Interface Unit indicates
the flight or ground status of the aircraft.
This information is used by the HF BITE, in order to
count the flight legs in case of CFDIU failure.
CFDS
For maintenance purposes, Built In Test Equipment is
integrated in the HF transceiver.
The BITE functions of the HF transceiver are monitored
by the Centralized Fault Display System.
TMUCOMW04-T02 LEVEL 3
EFFECTIVITY 23-11-00 Page 4
Jul 31/00
_A319/A320/A321 TECHNICAL TRAINING MANUAL
MECHANICS / ELECTRICS & AVIONICS COURSE 23 COMMUNICATIONS
UF94200
EFFECTIVITY Page 56
ALL
TMUCOMW04-P02 LEVEL 3
HF SYSTEM ARCHITECTURE
EFFECTIVITY 23-11-00 Page 5
Jul 31/00
_A319/A320/A321 TECHNICAL TRAINING MANUAL
MECHANICS / ELECTRICS & AVIONICS COURSE 23 COMMUNICATIONS
UF94200
EFFECTIVITY Page 57
ALL
THIS PAGE INTENTIONALLY LEFT BLANK
TMUCOMW04 LEVEL 3
EFFECTIVITY 23-11-00 Page 6
Jul 31/00
_A319/A320/A321 TECHNICAL TRAINING MANUAL
MECHANICS / ELECTRICS & AVIONICS COURSE 23 COMMUNICATIONS
UF94200
EFFECTIVITY Page 58
ALL
23 - COMMUNICATIONS
23-12-00 VHF SYSTEM PRESENTATION
CONTENTS:
Purpose
Principle
Components
TMUCOMF02 LEVEL 1
EFFECTIVITY 23-12-00 Page 1
May 31/00
_A319/A320/A321 TECHNICAL TRAINING MANUAL
MECHANICS / ELECTRICS & AVIONICS COURSE 23 COMMUNICATIONS
UF94200
EFFECTIVITY Page 59
ALL
VHF SYSTEM PRESENTATION
PURPOSE
The VHF system allows short distance voice
communications between different aircraft (in flight
or on ground) or between the aircraft and a ground
station.
The VHF is used for short range voice communications.
PRINCIPLE
For voice communications, the crew uses acoustic
equipment.
- side-stick radio selectors,
- loudspeakers,
- oxygen-masks,
- boomsets,
- headsets,
- hand-microphones.
The Audio Management Unit (AMU) acts as an interface
between the crew and the VHF system.
The Audio Control Panels (ACPs) allow selection of the
VHF1,VHF2, or VHF3 transceiver in transmission or
reception mode and for the control of the received
audio signal.
The Radio Management Panels (RMPs) serve to select the
VHF frequencies.
The VHF transceiver, tuned on the frequency selected
by one of the 3 Radio Management Panels (RMPs),
transforms the audio signals into VHF signals (in
transmission mode) or VHF signals into audio signals
(in reception mode).
TMUCOMF02-T01 LEVEL 1
EFFECTIVITY 23-12-00 Page 2
May 31/00
_A319/A320/A321 TECHNICAL TRAINING MANUAL
MECHANICS / ELECTRICS & AVIONICS COURSE 23 COMMUNICATIONS
UF94200
EFFECTIVITY Page 60
ALL
VHF SYSTEM PRESENTATION
TMUCOMF02-P01 LEVEL 1
EFFECTIVITY 23-12-00 Page 3
May 31/00
_A319/A320/A321 TECHNICAL TRAINING MANUAL
MECHANICS / ELECTRICS & AVIONICS COURSE 23 COMMUNICATIONS
UF94200
EFFECTIVITY Page 61
ALL
VHF SYSTEM PRESENTATION
COMPONENTS
Let’s see the main components of the VHF system.
The VHF system comprises:
- 3 VHF transceivers (1),
- 3 blade antennae,
associated with control systems:
- 3 RMPs (2),
- 3 ACPs (2),
- 1 AMU (1).
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:ATA 23 COMMUNICATIONS(10)