INSTRUCTOR ONLY INSTRUCTOR ONLY
CCQ FMGS SESSION GUIDE CCQ FMGS SESSION GUIDE (END)
. 1 : Point out the data base check technique. Select SOFTWARE STATUS/XLOAD function. The 6 P/N XLOAD and P/N STATUS pages should be observed and mention the update function, if FM differences are detected. Point out the keyboard differences, if applicable (ATC COMM and lateral/ vertical slew key presentation).
. 2 : CO ROUTE and FLT NBR have 10 digits either. ALTN entry is shifted to the left hand keys.
. 3 : DATA INDEX has 2 pages. Explain the link to A/C Status and to IRS checking. Mention the GPS deselect function.
. 4 : Check FPLN entirely using the correct procedure. VERT REV at 1st CRZ WPT and enter a STEP CLB to . Point out the OPT STEP function and presentation.
. 5 : AWY entry function with automatic selection of intersections. Mention the max num-ber of entries.
. 7 : Mention the ILS presentation (F and B). Explain the meaning and the capability for LOC BACK CRS approaches and flying the opposite LOC beam as required by SIDs.
. 8 : Enter the given TRIP WIND. Check and review the fuel figures.
. 9 : Notice DRT TO (Derated Take off) and FLEX TO (Flexible Temperature Take off). Set for the 1st take off D12. Mention the use of DRT TO and the calculation principles (specific RTOW charts). Into PERF CLB preset 230 kt. Set DRT CLB for demo [D2].
. 10 : Demonstrate the use of NAV B/UP and under what circumstances. Point out the accessible MCDU pages, the presentation and the WPT entry technique. Recover normal configuration after demonstration. B/UP F-PLN, B/UP F-PLN for DIR TO, B/UP PROG (entry or check downloaded WPTs) and B/UP IRS (on-side IR and IR3).
. 11 : For RTA DEMO VERT REV at origin and set an appropriate ETT (ETD) as a time constraint. Observe the presentation. VERT REV at . Set into the field and check predicted ETA and set into RTA field a time by more than 2 mn different from ETA. Observe constraint and MCDU amber warning. For CMS DEMO VERT REV at 1st CRZ WPT and enter into MACH/START WPT .82. Into END WPT enter the WPT found just prior to T/D. Observe the presentation on VERT REV page and on FPLN A or B. Check on whether the constraint will match or not. Check the CMS behaving in case of S/C-S/D.
A330 CCQ A320 TO A330 COURSE GROUND COURSE SYLLABI 02.03 G FQE Page 2C
FLIGHT CREW TRAINING PROGRAM Issue 00 FEB 2005
. 13 : Prepare the take off and prior to power application. Point out TOGA is not permitted with DRT TO use. Observe the specific FMA announcements in case of DRT TO. FREEZE after take off. Set a FLEX TO F51, STORE MEMO again and perform a normal take off. Advise RWY HDG until passing ALT. Review the pre-selected speed and return to normal speed schedule. When CLB phase active point out the DRT CLB function and clear it after a certain while in order to demonstrate that it maybe cancelled with the CLB phase active. 中国航空网 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址：A330 FLIGHT CREW TRAINING PROGRAM CCQ A320 TO A330 COURSE A330机组训练大纲交叉驾驶资格(5)
