TB 20 MAINTENANCE MANUAL 06 06 DIMENSIONS AND AREAS TB20飞机维护手册 06 尺寸和区域(12)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

Aileron control rod
Air vent hose
Wing tip gage (float gage) or Wing tip gage oscillator
617 Wing tip Navigation light Anti-collision light Internal end area
619 Inspection door
(specific to SEFA aircraft) Center area behind spar Spar (rear side)
Aileron linkage
Air vent hose
Root gage (float gage) or Root gage oscillator
621 Fuel plug Tank (filling) Fuel gage
622 Inspection door Flux valve (if installed)
631 Inspection door Fuel tank

I ADAA
Validity S / N 1 - 9999 Pre-MOD. 151 06-30-00Page 30
(EA) SEP 04
 
Intrados voilure gauche Intrados voilure droite
L.H. wing lower surface R.H. wing lower surface
 

 
Inspection doors - Areas 500 / 600 - Upper surface
Figure 9
I ADAA
Validity : S / N 1 - 9999 Pre-MOD. 151 06-30-00Page 31
(EA) SEP 04
 
E. Area 700 - Landing gear (Figures 10 and 11)
Identification
No. DESCRIPTION AREA LOCATION
AND ACCESSIBLE ELEMENTS
715 Door Nose gear leg
737 Trim L.H. wheel and axle attachment
738 Door L.H. main landing gear leg
747 Trim R.H. wheel and axle attachment
748 Door R.H. main landing gear leg

ADAA
Validity S / N 1 - 9999 Pre-MOD. 151
06-30-00Page 32
(EA) SEP 04
 
 
 

 
Doors - Area 700
Figure 10
I ADAA
Validity : S / N 1 - 9999 Pre-MOD. 151 06-30-00Page 33
(EA) SEP 04
 
 
 
14324000AAAKVZ14000 Inspection doors - Area 700
Figure 11
I ADAA
Validity S / N 1 - 9999 Pre-MOD. 151 06-30-00Page 34
(EA) SEP 04
 
INSPECTION DOORS
DESCRIPTION AND OPERATION
1. GENERAL
The inspection or service doors generally include all openings which facilitate maintenance practices or which allow access to certain components.
To facilitate their localization, the inspection doors are identified by a three- or four-digit number, sometimes followed by a letter.
The first two digits are identical to the first two digits of the secondary area concerned - refer to 06-20-00. The final digit(s) is (are) the sequence number within the secondary area. This number is attributed in the following order : FWD - aft, interior - exterior, top - bottom. A letter "L" (left), "R" (right), "C" (center), "F" (FWD), "A" (Aft), "T" (top) or "B" (bottom) may be used to complete an element's identification.
Eg :
211L
 

 
AGAB
Validity : S / N 1 - 9999 Post-MOD. 151
 
06 30-00Page 1
(EM) SEP 04
 
2. DESCRIPTION
A. Area 100 - Power plant
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：TB 20 MAINTENANCE MANUAL 06 06 DIMENSIONS AND AREAS TB20飞机维护手册 06 尺寸和区域(12)