• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-03-31 07:57来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

(2)  
Because the extent of repair and replacement will vary with each engine, the type of test required to ensure that satisfactory maintenance has been performed will vary also. To minimize ground running and to conserve fuel, this section provides ground test procedures which are related to the extent of repair or replacement. Prior to testing an engine after repair or replacement, see the Repair Reference Table (Fig. 501), to determine the test required.

(3)  
A pretrimmed engine is an engine that has been trimmed and acceleration/deceleration checked on a test stand in accordance with following:

(a)  
Trim and check runs were accomplished with following items installed: 1) Flight inlet (nose cowl) or bellmouth without screen: 2) Flight exhaust system or reference tailpipe. 3) All quick-engine-change (QEC) accessories (Ref 71-03-01, Boeing 737

Overhaul Manual, Power Pack Assembly (Engine Buildup Section)].

(b)  
Trim targets and acceleration/deceleration check requirements were as specified  in 71-09-200, Power Plant (JT8D) - Trim Procedure.

 


B.  Equipment and Materials
(1)  
Airplane interphone equipment

(2)  
Jetcal Analyzer, or equivalent (Howell Instruments, Inc., Ft. Worth, Texas)


C.  Prepare for Power Plant Test
(1)  
When cleaning engines prior to tests, following precautions must be taken:

(a)  
Protect all prepacked bearings, such as cross-shaft or control rod linkage bearings.

CAUTION:  IF FUEL LINES ARE TO BE DISCONNECTED, PREPACKED BEARINGS IN THE AREA MUST BE PROTECTED FROM ANY LOST FUEL.

(b)  
Protect pressure ratio bleed control.

(c)  
Protect silicone rubber shock mounts on oil tank and oil tank strap. Wash down area as soon as possible after washing with cleaning solution.

 

(2)  
Connect interphone equipment at engine to be tested.

(3)  
Remove engine cowl panels.

(4)  
Refer to 71-09-100, Power Plant (JT8D)-Operating Procedure, for engine start
procedures.

 

501 
May 15/78  BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.  71-00 Page 501 


Units Replaced or Required  Testing and/or Minimum Thrust Required for Ground Check Run 
Accessory Drive Anti-Icing Valve Bearing, No. 6 No. 1 or No. 6 Bearing Oil Scavenge Pump Bleed Valves (Anti-Surge) Combustion Chambers Combustion Chamber Outlet Ducts (Inner and Outer) Compressor Inlet Section No. 1 Bearing and Seal, Inlet Case, Disk Spacer, Individual Fan Blades, 1st- and 2nd-Stage Fan Blades, 1st-and 2nd-Stage Stators, Fan Cases 1st- and 2nd-Stage Disk and Blade Assembly FILTERS   Fuel Pump Filter  P&D Valve Strainer  Fuel Control Filter Fuel Control Fuel Deicing Heater Fuel Deicing Shutoff Valve Actuator Fuel Flow Transmitter Fuel Manifold Assembly Fuel Nozzles  Test A *[1] Observe Valve Position Indicator on Body of Valve While Actuating System from Cockpit, with Engine Not Running Test H and Breather Test Ref 79-21-0 Test A *[1] or monitoring Test E Test B Test F Test B, H Test H and Ref 79-21-0 MP *[7] Test C Test D, G Test C Observe Valve Position Indicator on Body of Valve While Actuating System from Cockpit, with Engine Not Running Test C Test B, G Test B, G 

Repair Reference Table  501 
71-00  Figure 501 (Sheet 1)  May 01/99 
Page 502 
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 


Units Replaced or Required  Testing and/or Minimum Thrust Required for Ground Check Run 
Fuel Pump (Same Fuel Control) Fuel Pump (Different Fuel Control) Fuel P&D Valve Fuel Pressure Differential Switch Fuel-Oil Cooler Fuel-Oil Cooler Bypass Valve Gearbox, Main Accessory Drive Ignition Components Instrumentation   Pt7 Probes and Tubing   EGT Probes and Harness Oil Pump Oil Strainer/Filter Oil Pressure Regulating Valve Oil Tank Pressure Ratio Bleed Control Start Valve Tubing    Fuel (Low Pressure)   Fuel (High Pressure)   Oil   Anti-Surge Bleed Valve Turbine Nozzle (Vanes)  Test B, G *[3] Test D, G Test C *[4] Test A Test C Test A Test B Aural Check Test B Test A *[1] Test A *[1] *[7] Test A *[2] Test A *[1] Test E Check that starter cutout (N2 RPM) is normal on first engine start. On start valve with open indication light, check that light is also extinguished Test A Test C Test A *[1] Test E Test B 
Gravel Protection System  Test B 

511  Repair Reference Table 
May 01/99  Figure 501 (Sheet 2)  71-00 
Page 502A/502B 
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:737 AMM 飞机维护手册 动力装置 POWER PLANT(11)