曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
When pushed, the ACTIVE window displays
the tuned frequency and the STBY/CRS
window displays the Standby frequency.
SEL Indicator
Illuminates on both RMPs when a transceiver
normally associated with an RMP is tuned by
another RMP.
Frequency Selector Knobs
Selects the course or standby radio frequency.
Displayed in STBY/CRS window.
Inner knob controls decimal values.
NAV Switch (Guarded)
When pressed on RMP 1 or 2, the radio
navigation backup
mode engages.
Removes autotuning
from the FMGC and the
VOC, ILS and ADF receivers are controlled by
the RMP.
The switch illuminates green when pushed.
Pushing switch a second time returns control
to the FMGC.
STBY NAV Selection Switches (VOR, ILS,
MLS & ADF)
When the NAV switch is selected, enables
tuning of the selected navaid via the frequency
selector knobs.
Each RMP tunes its respective VOR.
Tuning an ILS on either RMP tunes both ILS
receivers, if both RMPs are in the standby NAV
mode.
The ADF can only be tuned on RMP 1.
BFO Switch
When selected, the Beat Frequency Oscillator
mode becomes active, provided the ADF
receiver is selected.
ON/OFF Switch
Controls the power supply to the Radio
Management
.
Click to buy NOW!
PDFXCHANGE
www.docutrack.
com
Click to buy NOW!
PDFXCHANGE
www.docutrack.
com
Flight Deck Documentation AIRBUS A320
12.11.06 Ralf Anderseck Seite 302.2.14.
Flight Controls & Cargo Heat(A320)
Flight Controls
ELAC Switch
· ON Engages
the associated elevator
and aileron computer.
· OFF Disengages
associated
computer.
· Fault Light Illuminates
amber:
· When a failure is detected
· During ELAC power up test.
·
SEC 2/3 Switch
· ON Engages
the associated spoiler
and elevator and aileron computer.
· OFF Disengages
associated
computer.
· Fault Light Illuminates
amber when a
failure is detected.
·
FAC Switch
· ON Engages
the associated flight
augmentation computer.
· OFF Disengages
associated
computer.
· Fault Light Illuminates
amber when a
failure is detected.
Cargo Heat
HOT AIR Switch
· AUTO Automatically
controls Cargo
Heat pressure regulating valve.
· OFF Closes
Cargo Heat pressure
regulating valve and reset fault circuit.
· Fault Light Illuminates
amber when
duct overheat is detected and
extinguishes when temperature drops
and OFF is selected. System then
resets with ISOL VALVE switch ON.
·
AFT ISOL Valve Switch
· AUTO Opens
inlet and outlet
Isolation valves and activates
extraction fan provided there is no
smoke detected in the AFT cargo
compartment.
· OFF Closes
inlet and outlet Isolation
valves and turns off extraction fan.
· Fault Light Illuminates
amber when
either inlet or outlet valve is in
Click to buy NOW!
PDFXCHANGE
www.docutrack.
com
Click to buy NOW!
PDFXCHANGE
www.docutrack.
com
Flight Deck Documentation AIRBUS A320
12.11.06 Ralf Anderseck Seite 31disagreement
with the selected
position.
·
Temperature Selector
Adjust temperature for AFT Cargo
compartment.
· COLD Approximately
40°F
· HOT Approximately
80°F
· Center Approximately
60°F
Click to buy NOW!
PDFXCHANGE
www.docutrack.
com
Click to buy NOW!
PDFXCHANGE
www.docutrack.
com
Flight Deck Documentation AIRBUS A320
12.11.06 Ralf Anderseck Seite 322.2.15.
Cargo Smoke Panel ( A320 )
A320 Cargo Smoke Panel
Smoke Light (red) FWD / AFT
Illuminates when smoke is detected in
respective Cargo compartment. Activated by
both loops or by one loop if the other is faulty.
Activation of the AFT CARGO SMOKE light
also closes the AFT Cargo inlet and outlet
isolation valves and shuts off the AFT Cargo
extraction fan.
A320 TEST Button
· Tests smoke detectors in sequence.
· Tests SMOKE lights twice with
associated ECAM.
· Closes ventilation system isolation
valves.
· Tests DISCH lights.
·
DISCH Agent 2 Light (amber)
· Illuminates 60 minutes after Agent 1 is
discharged in the FWD or AFT
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
A320 Flight Deck Documentation(11)
