曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
inclines. Use minimum power to maintain constant taxi speed.
“Riding the brakes” while taxiing is similar to driving a car with one foot
on the brake and one foot on the gas. This causes a continuous build
up of energy that would otherwise be moving the airplane.
Observe the following operating practices:
• Verify that the parking brake is completely disengaged before
taxi.
• The rudder is effective for steering on the ground and should be
used.
March 2010
Cirrus Design Section 10
SR22 Safety Information
Information Manual 10-11
• Use only as much power (throttle) as is necessary to achieve
forward movement. Keep in mind, any additional power added
with the throttle will be absorbed in the brakes to maintain
constant speed.
• Use rudder deflection and the minimum necessary inputs of
differential braking to achieve directional control.
• Do not “ride the brakes”. Pilots should consciously remove
pressure from the brakes while taxiing. Failure to do so results in
excessive heat buildup, premature brake wear, and increased
possibility of brake failure or fire.
• Avoid unnecessary high-speed taxiing. High-speed taxiing may
result in excessive demands on the brakes, increased brake
wear, and the possibility of brake failure or fire.
• Brakes have a large energy absorbing capacity; therefore,
cooling time should be considered. Energy absorbed during a
few seconds of deceleration can take up to an hour to dissipate.
Always allow adequate cooling time after brake use.
• Allow a cooling period following a high-energy braking event.
High-energy braking can include an aborted takeoff or the
equivalent energy required for a Maximum Gross Weight fullstop
from 70 knots in less than 1000 feet.
Brake Maintenance
The brake assemblies and linings should be checked at every oil
change (50 hours) for general condition, evidence of overheating, and
deterioration. Serials 0002 thru 3450 before SB 2X-05-01: At every
annual/100-hour inspection the brakes should be disassembled, the
brake linings should be checked and the O-rings must be replaced.
Refer to Section 8, Handling, Servicing, and Maintenance for specific
servicing information on the Brake System.
March 2010
10-12 Information Manual
Section 10 Cirrus Design
Safety Information SR22
March 2010
Intentionally Left Blank
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
西锐20飞机信息手册 SR22 AIRPLANE INFORMATION MANUAL 2979(124)
