5. Partition Installation
(Figure 401)
A. General
(1) This task includes the steps to install the Partition.
B. Location Zones
Zone Area
200 Upper Half of Fuselage
EFFECTIVITY: 003‐004, 008‐011 AAR PROPRIETARY - Do not copy without express permission of AAR 25-24-16 PAGE 403 AUG 25/11
C. Procedure
SUBTASK 25-24-16-420-017
(1) Do these steps to install the outboard top support attachment if it was removed (Figure 404):
NOTE: It was not necessary to disconnect or remove the outboard A/C top support attachment to remove the partition [1].
(a) Put the partition attachment assembly [45] in its position on the A/C extrusion.
(b) Put the extrusion attachment assembly [46] in its position under the A/C extrusion adjacent to the partition attachment assembly [45].
(c) Loosely install the locking screw [48] and the washer [49].
(d) Tighten the setscrew [47] to 10 to 15 pound-inches (1.1 to 1.7 newton-meters).
(e) Tighten the locking screw [48].
(f) Make sure that the partition attachment assembly [45] and the extrusion attachment assembly [46] are in the correct location.
NOTE: The attachment assemblies must be installed in the correct location before you continue the installation.
SUBTASK 25-24-16-420-018
(2) Carefully put the partition [1] in its correct location.
SUBTASK 25-24-16-420-019
(3) Do this task: Bottom Attachment Installation, TASK 25-24-16-400-804.
SUBTASK 25-24-16-420-020
(4) If applicable, do this task: Top Attachment Installation, TASK 25-24-16-400-805.
SUBTASK 25-24-16-840-001
(5) Do this task: Put the Airplane Back to Its Usual Condition, TASK 25-24-16-840-802.
------------------------ END OF TASK ---------------------------
EFFECTIVITY: 003‐004, 008‐011 25-24-16 PAGE 404
AUG 25/11
AAR PROPRIETARY - Do not copy without express permission of AAR
TASK 25-24-16-400-804
6. Bottom Attachment Installation
(Figure 401, Figure 403)
A. General
(1) This task includes the steps to install the bottom attachment(s).
B. Location Zones
Zone Area
232 Forward Passenger Compartment - Forward Entry Door to Sta 663.75 - Right
C. Procedure
SUBTASK 25-24-16-420-021
(1) Put the seat track fittings in the seat tracks, if applicable.
SUBTASK 25-24-16-420-022
(2) Do these steps to install a partition [1] with Seat Track Attachment Type 1 Fittings:
(a)
Connect the seat track fittings to the seat track.
(b)
Engage the plunger on the seat track fitting.
(c)
If applicable tighten the anti-rattle setscrew after engaging the plunger.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：INSTRUCTIONS FOR CONTINUED AIRWORTHINESS (ICA) 持续适航说明(10)
