曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
Apply a thin bead of RTV sealant on the shroud mounting surface and install, insuring correct orientation (refer to Repair, Section 8).
CAUTION: DO NOT OVER TORQUE SCREWS, OR DAMAGE TO THE SHROUD AND COIL MAY RESULT.
9.5.1.3
Install mounting hardware (40,50,60) (refer to table 1, Section 1 for torque specifications).
9.5.2
Assembly of Condenser Blower (70)
9.5.2.1
Apply a small bead of RTV sealant on the condenser shroud and install the vane axial blower insuring the orientation of the wires are correctly positioned.
CAUTION: DO NOT OVER-TORQUE MOUTING SCREWS OR THREAD DAMAGE MAY RESULT.
9.5.2.2
Install all mounting screws and washers (80, 90) and torque (refer to Standard Torque Values, Section 1.3).
9.5.2.3
Rotate blower wheel to ensure there is no rubbing and that the blower outlet is free of all foreign matter and obstructions.
Component Maintenance Manual
12037 N Highway 99
Seminole, OK 74868
Phone (405) 382-0731
Fax (405) 382-0737
http://www.enviro-ok.com
EFFECTIVITY: ALL 21-00-08
Page 7009
JULY 2/ 2007
9.5.2.4
Connect motor wiring, then connect power leads to condenser blower and perform functional test per Testing and Fault Isolation, Section 3.2.
Component Maintenance Manual
12037 N Highway 99
Seminole, OK 74868
Phone (405) 382-0731
Fax (405) 382-0737
http://www.enviro-ok.com
EFFECTIVITY: ALL 21-00-09
Page 9001
FEBRUARY 16, 2010
SPECIAL TOOLS, FIXTURES, AND EQUIPMENT
TASK 21-00-09-99F-803
10.0
SPECIAL TOOLS/EQUIPMENT
SUBTASK 21-00-09-99F-014
10.1
General:
10.1.1
This section describes the necessary tools and test equipment required to perform maintenance, functional testing, troubleshooting, and repair procedures. Equivalent test equipment may be substituted only if it meets the listed equipment specifications.
•
Regulated Shop Air 40 PSIG
•
Fin comb SK1250101-13
•
Miscellaneous hand tools and socket set
•
Shop vacuum with soft utility brush
•
Gates Sonic Tension Meter 507C (www.gates.com)
•
Vacuum pump, air or electric 0-30 in.hg.
•
Gaseous dry Nitrogen, regulated source 0-500 PSIG
•
Reclaim/Recycle Cart (R-134a) (Robinair model # 342000) (preferred) or R-134a refrigerant charging manifold with gauges and hoses.
•
Thread sealant primer Loctite 7471
•
Thread sealant Loctite 569
•
Loctite primer N7649
•
RTV sealant 11602 Black
•
Hose adapter 1/2 in. male ACME to 1/4 in. female flare
•
Leak check fluid soap solution
•
Refrigerant oil contact Enviro for proper oil type
•
External or aircraft power source 200 amp.
•
Inspection mirror
•
Thermometer 0-150°F
•
Flashlight or service lamp
•
Refrigerant R-134a or R-12
•
Kent-More Flush Adapter J42939
•
Small “rare earth” magnet
•
Tape
•
Straight Edge
•
Measuring Device
•
Micrometer
•
Scribe or Wire Hook
•
Volt-OHM Meter
Component Maintenance Manual
12037 N Highway 99
Seminole, OK 74868
Phone (405) 382-0731
Fax (405) 382-0737
http://www.enviro-ok.com
EFFECTIVITY: ALL 21-00-09
Page 10001
FEBRUARY 16, 2010
ILLUSTRATED PARTS LIST
TASK 21-00-09-98-801
11.0
R-134a AIR CONDITIONING SYSTEM COMPONENT ILLUSTRATED PARTS LISTING
SUBTASK 21-00-09-99F-015
11.1
Introduction:
11.1.1
This Illustrated Parts Listing (IPL) is intended for use during testing and isolation, disassembly, cleaning, check (inspection), repair, assembly, and issuing the replaceable equipment components as well as in identification of new and reclaimed parts.
11.1.2
This IPL includes illustrations of the Compressor Drive Module, Condenser Blower Assembly, and the Evaporator Module Assembly to be used during the procedures outlined previously.
11.1.3
This IPL includes figure and item numbers to call out specific components. Each component will be assigned an item number. Items listed but not shown are identified by a dash preceding the item number. The figure refers to the exploded view of the equipment.
11.1.4
This IPL includes a part number for each component called out in the illustration that is a field replaceable component.
11.1.5
This IPL includes nomenclature for each component that helps with identification.
11.1.6
This IPL includes units per assembly for each component called out in the illustration that is a field replaceable component.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
OPERATING, SERVICING, AND COMPONENT MAINTENANCE MANUAL(23)
