• 热门标签

当前位置: 主页 > 航空资料 > 飞行资料 >

时间:2010-06-12 22:08来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

malfunctioned.
The ORT VID RCD switch has been pressed and the video recorder has stopped
recording.
PNVS is the sight in use.
The boresight mode is in effect.
TM 1-1520-238-10
Table 4-20. Alpha/Numeric Display Message Location and Description - continued
Message
IRIS.. .BORESIGHT
LIMITS
PILOT...CONTROLS...
TADS
IMPEND...LASER...
INHIBIT
LASER...INHIBIT
INVALID...PILOTLOS
SLAVE PL
SLAVE TG
SLAVE NV
INVALID...TARGTLOS
INVALID...NAV LOS
SYMBOL G
KBRDFAIL
TADS TEMP
TADS NOT. . READY
LRFD . . . COOLANT
ENRGY LO
WEAPON STATUS
Description
The TADS is at an azimuth or elevation gimbal limit.
The acquisition select switch is in PLT.
The acquisition select switch is in TGT.
The acquisition select switch is in NAV.
There are no valid UTM coordinates in the FCC for the target number selected on
the thumbwheel switch.
The symbol generator has been detected as NO-GO.
The data entry keyboard (DEK) has been detected as NO-GO.
The TADS has been selected and the turret internal temperature has been detected
as overheating.
The TADS has been selected and the turret internal temperature has not reached
operating temperature.
The TADS LRF/D power is on and the transceiver coolant level has been detected as
low. The LRF/D temperature is above maximum limit.
The TADS LRF/D power is on and the output energy level has dropped below a
specified level.
SECTION
WEAPON?
GUN FAIL
TADS FAIL
RNDSDDDD
RKT FAIL
RKTINV?
A weapons trigger has been pulled without a weapon selection.
The selected video is not operational.
The rocket subsystem has been checked and is in a NO-GO state; message blinks at a
2 Hz rate.
Rockets have been actioned but the FCC has no rocket inventory. Re-inventory can
be accomplished by cycling pilots SAFE/ARM switch to OFF, then back to
SAFE/ARM.
Change 4 4-55
TM 1-1520-238-10
Table 4-20. Alpha/Numeric Display Message Location and Description - continued
Message
ROCKETS
TOF=TT
MSL FAIL
INVALID...COMMAND
NO TYPE
BIT IN...PROGRESS
PLT MSL
HANGFIRE
MSL SEL?
ZONE?
MSL LNCH
FIRE... MISSILES
SIM LNCH
TOF = TT
RF ORIDE
2
CHANLS...TRACKING
PRI
CHAN...TRACKING
ALT
CHAN...TRACKING
Description
The rocket system has been actioned with neither crewmember RKT select switch in
GND STOW-and airspeed less than 100 KTAS as sensed by the ADSS.
The WAS is in the rocket position. The trigger has been pulled. The message
indicates the time of flight to impact in seconds, decrementing.
The type of missile selected on the missile control panel is not present on the
launchers.
The pilot has control of the missile system.
Missiles have been actioned but no missiles have been selected.
Rockets have been actioned but no zone has been selected for firing.
A training missile is being utilized.
The WAS is in the MSL position. The trigger has been pulled. Time of flight in
seconds to impact, decrementing.
NOTE
If no channels are tracking, the weapon status section will display the delivery mode and the firing
delivery mode. The delivery messages are “HI“, “LO”, “DIR’, or “LOBL”. The fire delivery messages
are “NORM”, “STBY”, “MANL”, or “RIPL” (i.e., “LOBLNORM”).
TRACKER STATUS SECTION
TADS...STOWED
TADS...FORWARD
LST FAILED
LST TRACKING
The TADS is either stowed or in an internal boresight mode.
LST tracking remotely designated laser energy.
4-56 Change 1
TM 1-1520-238-10
Table 4-20. Alpha/Numeric Display Message Location and Description - continued
Message
LST SEARCH
LST AUTO SEARCH
IAT FAILED
IAT BREAK- LOCK
IAT OFFSET
IAT TRACKING
IAT B/W
IAT W/B
IAT AUTO
ENERATOR
RKT-G-S
RKT-F-S
LIMITS
SIGHT?
LASE 1 . . . TARGET
LASE2. . . TARGET
LASE3. . . TARGET
LASE 4 . . . TARGET
THRU
LASE 16 . . . TARGET
Description
Manual search.
LST scanning in a programmed search pattern.
Image auto tracker has broken track.
IAT offset tracking engaged.
IAT polarity is black on white.
The symbol generator has been detected as NO-GO.
LST AND LRF/D CODES STATUS SECTION
CODE
LST=CRFD=D
RFD = D
LST = C
LSR CCM
NOTE
If neither system is operable, the section is blanked.
Both systems are operational and the code selected by the FCP pushbutton is
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:阿帕奇攻击直升机操作手册2(12)