• 热门标签

当前位置: 主页 > 航空资料 >

时间:2011-03-10 09:02来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

ADC
FMGC
TLA out of
ATS range
ATHR
ATS
or
EIU
Upper ECAM DU
Disengaged Actual N1
Fuel flow
control
N1 THR ECU
N1
limit
N1
limitation
N1
Thrust
lever
comput.
N1 limit
compu
tation
N1 target
or
Manual
mode
Auto
mode
Instinctive
disconnect PB
ATS not active
STL 945.7136/97 8.9
A319/A320/A321 engine controls – thrust control schematic
IAE V2500
ADC
TLA out of FMGC
ATS range
ATHR
ATS
or
EIU
Upper ECAM DU
Disengaged Actual EPR
Fuel flow
control
Trottle EEC EPR
EPR
limit
EPR
target
limitation
EPR
Thrust
lever
comput.
EPR
limit
computa.
and selec.
EPR target
or
Manual
mode
Auto
mode
Instinctive
disconnect PB
ATS not active
N1 mode
selection
+
-

STL 945.7136/97 8.11
A319/A320/A321 engine controls – thrust control operations
Limited thrust parameters (N1 for CFM56, EPR for
V2500) computed by FADEC.
Selection of thrust limit mode obtained directly by throttle
position :
Six positions defined by detents or stops.
Thrust lever only to be moved manually (no
servomotor) : lever position not necessarily
representing engine thrust delivered
According to the thrust lever position the FADEC
computes :
- Thrust rating limit (no TRP)
- N1 (EPR) when in manual mode
- N1 (EPR) which can be achieved in
Go Around (GA)
Max Take-Off (TO)
Max continuous (MCT)
Flex. Take-Off (FLX) Max Climb (CL)
ATS max
operating range
Idle
Reserve idle
Max reserve
Reserve
Mode selection Thrust
Thrust limit T.O/GA
Thrust limit FLX TO/Max Cont
Thrust limit max climb
Command
f (TLA)
Max reserve
Max continuous
Climb
Cruise
Max take-off
Idle
STL 945.7136/97
A319/A320/A321 engine controls indications (CFM56) on ECAM upper DU
Appears when both
engines at IDLE (*)
Transient N1 during ATS operation
corresponding to FMGC demand to
go to N1 target
8.12
Symbol corresponding to
the thrust lever position
N1 actual
Exhaust gas
temperature
* Basic on A319/A321
Max N 1
Max permissibleN1
Flex temperature
(entered through MCDU)
N 1 rating limit
FOB : 18000 KG
S
F
3
FLX
SEAT BELTS
NO SMOKING
IDLE
Thrust limit mode
STL 945.7136/97
A319/A320/A321 engine controls indications (IAE 2500) on ECAM upper DU
Appears when both
engines at IDLE (*) Transient N1 during ATS operation
corresponding to FMGC demand to
go to EPR target
8.13
Symbol corresponding to
the thrust lever position
Actual N1
Exhaust gas
temperature
* Basic on A319/A321
Max EPR
Thrust limit mode
Flex temperature
(entered through MCDU)
FOB : 13000 KG E PR rating limit
SEAT BELTS F
NO SMOKING
Actual EPR
S FLAP F
1530 1 5 0 0
Max permissible N1
STL 945.7136/97
A319/A320/A321 EIS independent : after “clear” action
8.14
Start configuration
After start configuration
Oil quantity
Oil pressure
Oil temperature
Start valve
position
Engine bleed
pressure
Selected
ignition
TAT + 19 °C
SAT + 18 °C
23 H 56 G.W. 60300 kg
Nacelle temperature
TAT + 19 °C
SAT + 18 °C 23 H 56
G.W.
°
°
°
Engine vibration
STL 945.7136/97
A319/A320/A321 engine controls indications on PFD : FMA
8.15
The following indications may appear on the PFD Flight
Mode Annunciator (FMA), in upper left corner :
ASYM : Only one thrust lever is set to CLB or
MCT position,
CLB : Flashing when aircraft above thrust
reduction altitude and thrust levers
not in CLB notch,
MCT : Flashing in case of engine failure if the
non-affected thrust lever is not set at
MCT,
A-FLOOR : α -floor condition encountered,
TOGA LK : When leaving α -floor condition and
thrust still at MTO
FINAL APP NA
ASYM

STL 945.7136/97
A319/A320/A321 engine controls - thrust reverse
8.17
Reverser deployment selection by positioning thrust
lever into reverse area and by acting on independent
locking levers.
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A319/A320/A321飞行员驾驶舱和系统简介(14)