曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
CSP 700−5000−6
Volume 2
02−10−56
MODES OF OPERATION (CONT'D)
Landing Elevation (Cont’d)
When the LDG ELEV FMS/MAN selector is set to FMS, the landing destination information has
been programmed in the FMS and the flight plan activated, the LDG ELEV is displayed on the
STAT page.
GF0210_064
1300
0.10
300
120
CAB ALT
P
CAB RATE
LDG ELEV
ACTIVE FLT PLAN 5/6
CYUL
DEPARTURE PERF INIT
DEST
MAN
FMS
UP
DN
LDG ELEV
When the LDG ELEV FMS/MAN selector is set to MAN, the LDG ELEV selection is made from the
Pressurization Control Panel. The LDG ELEV is defaulted to 0 feet on the ground and 5,670 feet in
flight. A message is displayed on EICAS and will remain posted until a selection of UP or DN.
Effectivity:
• Airplanes 9127 thru 9158 not incorporating Service Bulletin:
• SB 700−1A11−21−004, Modification − Pressurization Control − Cabin Altitude Reduction
During Flight for Improved Passenger Comfort.
When the LDG ELEV FMS/MAN selector is set to MAN, the LDG ELEV selection is made from
the Pressurization Control Panel. The LDG ELEV is defaulted to 0 feet on the ground and 7,230
feet in flight. A message is displayed on EICAS and will remain posted until a selection of UP or
DN.
GF0210_065
8300
0.08
300
7230
CAB ALT
P
CAB RATE
LDG ELEV
SET LDG ELEV
MAN
FMS
UP
DN
LDG ELEV
AIR CONDITIONING AND PRESSURIZATION
Rev 12, Aug 14, 2006 Flight Crew Operating Manual
CSP 700−5000−6
Volume 2
02−10−57
MODES OF OPERATION (CONT'D)
Landing Elevation (Cont’d)
To enter a new LDG ELEV, hold the UP/DN switch until desired field elevation is reached.
GF0210_066
1300
0.00
300
120
CAB ALT
P
CAB RATE
LDG ELEV
MAN
FMS
UP
DN
LDG ELEV
Manual Mode
In the manual mode, cabin pressure is manually controlled by the crew selecting the applicable
switches on the Pressurization control panel.
AUTO/MAN switch
Used to select mode of
operation.
−Indicates AUTO
mode is selected.
−Indicates MAN
mode is selected.
MAN ALT Toggle switch
Used to control cabin altitude in
manual mode.
Spring loaded to mid position.
UP − Commands cabin to climb.
DN − Commands cabin to descend.
Selecting the AUTO/MAN switch to MAN then
back to AUTO will enable the other CPC.
NOTE
GF0210_067 MAN
AUTO/
MAN
MAN
MAN ALT
UP
DN
MAN
MAN
Selecting MAN will display both outflow valve position indicators, display an analog rate of change
gauge and eliminate the LDG ELEV on the status page and display a status message on EICAS.
MAN Mode Data Display
CAB RATE − Sweep range
displayed in feet (−2500 to 2500 fpm).
LDG ELEV − Not displayed. Crew
OUTFLOW VALVES Position Indicators must monitor CAB ALT.
Displayed when MAN selected and measured in
percent. Also displayed when EMER DEPRESS
selected, or OUTFLOW VLV closed, or DITCHING
selected.
GF0210_068
20
1300
90
13% 13%
20 0.00
CKPT (°C)
OXYGEN
OPEN OPEN
OUTFLOW VALVES
CAB ALT
CAB RATE
P
0 0
1 2
1 2
1 2
AFT
CABIN (°C)
%
CABIN (°C)
23
19 21 22
FWD
MAN PRESS CONTROL
MAN
When the MAN ALT (spring loaded) toggle switch is selected to UP, both outflow valves open
slowly, and the cabin altitude increases proportionally to the outflow change.
GF0210_069
48% 48%
OPEN OPEN
OUTFLOW VALVES
1 2
MAN ALT
UP
DN
AIR CONDITIONING AND PRESSURIZATION
Flight Crew Operating Manual Rev 12, Aug 14, 2006
CSP 700−5000−6
Volume 2
02−10−58
MODES OF OPERATION (CONT'D)
Manual Mode (Cont’d)
When the MAN ALT toggle switch is selected to DN, both outflow valves close slowly and the
cabin altitude decreases proportionally to the outflow change.
GF0210_070
10% 10%
OPEN OPEN
OUTFLOW VALVES
1 2
MAN ALT
UP
DN
The desired control (climb, level, descent) is maintained by adjusting, if necessary, the outflow
valve positions, according to flow or differential pressure changes.
Manual Mode Operation
Operate pressurization, MAN/ALT toggle switches as required:
• To increase cabin altitude, select MAN/ALT toggle switch to UP momentarily and monitor
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
Bombardier_Global_000-Air_Cond_and_Press(21)
