曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
CFO1101002_005
FIRE
600 600
93.0 61.0
NI
MACH
HOLD
VIB VIB
ITT
IGN IGN
N2
OIL PRESS
OIL TEMP
FF PPH
84.7
46
115
7300
84.7
46
115
7300
APU RPM 300
APU EGT 250
FUEL QTY LBS
TOTAL 12000
6000 6000
START
START
STAB AIL
LWD RWD
RUD
L R
NU
ND
6.6
FLAPS 0 GEAR
SPOILERS
CAB ALT
CAB RATE
7300
1000
UP
O
DN
85.0 MCT 85.0 MCT TRIM
V T
MSGS
FLIGHT INSTRUMENTS
May 06/2005 Flight Crew Operating Manual Volume 2
REV 2 CSP 100-6 11-01-35
CONTROLS AND INDICATIONS (Cont)
MFD CONTROL PANEL (MCP)
DISPLAY CONTROL PANEL (DCP)
CAS
CKLST SKIP
FRMT TFC TR/WX ENTER SUMRY
A/ICE ECS ELEC FLT FUEL HYD
L R
CFO1101002_009
AUTO PLAN
SHLDR SIDE
1/2 DME/H NAVSRC
RADIO BRGSRC
FRMT TFC TR/WX
REFS RADAR
TUNE MENU DATA TILT RANGE
CFO1101002_007
SUP
H
AUTO
TLIT
SUP
H
TCELES
REV 2
FLIGHT INSTRUMENTS
Volume 2 Flight Crew Operating Manual Sep 13/2004
11-01-36 CSP 100-6 REV 1
CONTROLS AND INDICATIONS (Cont)
REVERSION CONTROL PANEL
STANDBY INSTRUMENT
TUNE
NORM CDU
ONLY
MFD
ONLY
COM 1
121.50
LEFT
DISPLAYS
NORM MFD
REV
PFD
REV
ATT/HDG
NORM
1 2
AIR DATA
NORM
1 2
RIGHT
DISPLAYS
NORM PFD
REV
MFD
REV
CFO1101002_008
CFO1101002_012
CAGE
STD
B
R
T
D
I
M
BARO
240
220
200
180
M. 47
1013.2 hPa
29.92 in
13000
128
40
20
00
9
1
10
10
20
ILS
12500
FLIGHT INSTRUMENTS
Sep 14/2005 Flight Crew Operating Manual Volume 2
REV 4 CSP 100-6 11-01-37
MULTI-FUNCTION/PRIMARY FLIGHT DISPLAY VISUAL ANNUNCIATIONS
If MFD or PFD data is invalid or missing, the following annunciations will be displayed on the MFD or PFD.
A brief explanation of each message is provided.
MESSAGE INHIBITS MEANING
AURAL
WARNING
AOA
A red, boxed, AOA flag shows to the right of the
vertical speed scale when no valid AOA data is
available. The flag flashes for five seconds,
then remains steady
ALT
Indicates an invalid altitude source. Crosscheck
standby instrument altitude to validate instruments
AP Indicates a monitored autopilot disconnect
ATT
Indicates an invalid attitude source and illuminates
in the center of the attitude sphere. Most
likely cause is an AHRS fault or failure
FD Indicates a fault in the flight guidance computer
FMS 1 FMS 2 Indicates that data from the active nav source is
missing or invalid
LOC 1 LOC 2 Indicates that data from the active nav source is
missing or invalid
VOR 1 VOR 2 Indicates that data from the active nav source is
missing or invalid
HDG
Indicates an invalid heading source and illuminates
in the center of the PFD heading display.
Most likely cause is an AHRS failure
IAS Indicates an invalid air data source and illuminates
in the center of the airspeed tape
MACH Indicates an invalid air data source and illuminates
in the center of the airspeed tape
RA Indicates an unreliable radar altitude
VNV Indicates when VNAV data from the FMS is
missing or invalid
VS
Indicates in place of the vertical speed scale
when vertical speed data from the air data computer
is missing or invalid
REV 4
FLIGHT INSTRUMENTS
Volume 2 Flight Crew Operating Manual Sep 14/2005
11-01-38 CSP 100-6 REV 4
EICAS MESSAGES
The flight instruments system messages are shown on the EICAS. In the table below, the EFIS messages and inhibits are
listed. A brief explanation of each message is provided.
MESSAGE INHIBITS MEANING
AURAL
WARNING
AIR DATA 1 (2) FAULT TO/LAND
The angle of attack input to the ADC has failed.
The affected altitude may indicate up to 150 ft
low
EFIS COMPARATOR
INOP TO/LAND
The EFIS comparator is unable to compare one
or more of the following parameters: altitude,
airspeed, roll attitude, pitch attitude, heading,
radio altitude, flight director, localizer
or glideslope
EFIS MISCOMPARE
There is a mismatch between the onside and
cross-side data. Accompanied by a PFD
annunciation ALT, IAS, ROL, PIT, HDG, LOC,
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
Bombardier_Challenger_Global_00-Flight_Instruments(17)
